Step 2
– To install the rubber feet on the bottom part of the case you will either have to push and
twist them through one of the 4 the holes or help yourself with a small screwdriver to tuck in the top
part of the feet within the hole as shown on the left. Be careful not to cut through the feet and rather
than using the tip of the screwdriver use the flat surface to push the head of rubber foot in.
Step 3
– Insert the Raspberry Pi and the Flick board in the bottom part of the case by first placing
the USB connectors in.
The PCBs of the two boards should be aligned within the grooves of the panel as shown in the
picture.
