Pre-planting
• Press Start to choose your growth plan.
• Choose one of the listed categories - one of the names
from the selected category - one of the strains.
• Watch Installing the pH sensor video.
• Remove Rockwool slab from Seedo.
• Open compartment on right of Seedo’s interior.
• The pH sensor is attached to the right side
of the compartment.
• Perform the following actions immediately
before you start the growth plan:
1. Remove tape and take out pH sensor.
2. Unscrew cup from bottom of sensor.
3. Insert sensor in compartment and push firmly into place.
• Replace slab inside Seedo.
• Only when you receive notification to do so,
use a cutter to make 6 incisions in nylon cover.
• Flip slab over.
• Note that the slab is now water-logged,
and is quite heavy and may drip.
• Press OK on the app.
1. Choose Growth Plan
3. Install pH Sensor
5. Prepare Slab for Planting
4. Rockwool Slab Watering
2. Choose Growth Type
After connecting Seedo to the app,
the Main Screen appears showing the name of the device.
Choose Seed or Clone. According to your choice,
the app will explain how to plant your seed/clone.
• It may take some time for Seedo to prepare
its water system for planting; you will receive
notification when it’s done.
• The watering process starts automatically as
soon as you choose the growth plan’s setting
and press Start Growing.
Do not proceed and plant yet.
Wait until slab watering is
completed.
!
!
!
Tip of pH sensor should not be in dry
environment for more than an hour.
Note: Now you will only need to proceed
with steps 3-4. Planting will be done only
when step 5 is completed.
