Seecode 232519, Instruction Manual, Page: 7 / 19

*This product is equipped with an LED lamp for dark areas
Adjust the pressure compensation:
Press `M` to select the unit. Press `+` or `-` to preset the pressure. Wait a few seconds until the display stops flashing. If the pump head is not con -
nected to a pressurising part (e.g. tyre, ball), the display will show „0.00“ again after a short time. If the unit is not used, the display switches off after
approx. 90 sec.
The last tyre pressure entered remains stored, even if the unit has been switched off completely. To check the current preset air pressure, press the ‚+‘
or ‚-‘ button once.
To measure the current air pressure, place the pump head on the valve with the rocker arm folded out and close the rocker arm (resting against the
pump head). If the measured air pressure is too high, open the rocker arm and release some air. Close the rocker lever again. The current air pressure
is shown on the display.
After the on/off switch has been pressed, the pumping process starts and is automatically switched off when the preset air pressure is reached. It takes
approx. 15-20 seconds to increase the air pressure of a car tyre from 2.0 to 2.2 bar. The times vary depending on the required pressure and the air
volume (e.g. tyre size).
During the pumping process, the battery charge level indicator may show a significantly lower remaining charge. This is not unusual with percentage
calculations of Li batteries. In the idle state, the charge level display will usually increase slightly again.
If you notice the unit heating up during use, please allow the unit to cool down for a few minutes before using it again.
Special features:
1. handheld air compressor, practical use
2. precise pressure indication
3. metal cylinder, fast heat dissipation, long durability
4. quick inflation, low noise
5. with LED light, practical use at night
6. pre-set print, automatic stop function
NOTE:
1. fully charge before use
During the charging process, an LED lamp in the USB plug to the mains adapter lights
up „red“, and „green“ when fully charged.
2. adjust the safety lock when the appliance is not in use
A
D
B
E F
C
Current pressure
Charge level indicator
Display
`+´ Key
`-´ Key
Main key