Powerstick
4 Connectors/Indicators
8
4.2
Connectors
XLR connectors (1)
The Powerstick should be connected with a standard symmetrically wired XLR cable. To connect
the input signal to further devices, use the male XLR Loop thru connector. To obtain full power
performance from the system, the signal source should be able to provide a minimum of 6 dBu
distortion free output voltage.
PowerCon blue (2)
Power supply input voltage 110-230 VAC. This connector provides the function of an on-off switch.
After powering on (turn the connector to the right until it locks), the systems starts up and is ready
for use after approximately 3 seconds. Avoid repeatedly switching the system on and off, particular-
ly when it is operating.
SpeakON (3)
This connector is used to connect additional passive loudspeakers to amplifier channel 1.
Coding: „1+/1- Out 1“. ATTENTION! The nominal impedance of the connected passive systems
must be 4 Ohm or more! In this connection mind the selection of the correct controller setup!
SpeakON (4)
This connector is used to connect additional passive loudspeakers to amplifier channel 2.
Coding: „1+/1- Out 2“. ATTENTION! The nominal impedance of the connected passive systems
must be 4 Ohm or more! In this connection mind the selection of the correct controller setup!
SpeakON (5)
This connector is used to connect a passive mid-high system in combination with a subwoofer sys-
tem by using system wiring.
Coding
: „1+/1- Out 1“ and „2+/2- Out 2“. ATTENTION! The nominal impedance of the connected
passive systems must be 4 Ohm or more on both the
„1+/- group“ and the „2+/- group“! In this con-
nection mind the selection of the correct controller setup!
The nominal power consumption of the Powerstick under full power is
0.75 A (measured with pink noise, Crest Factor 8). Transient peaks
can, however, cause much higher momentary power drain. Observe
carefully the nominal power consumption when connecting the loud-
speaker(s) to the power source, and observe carefully the cut-off
current of the safety circuit breakers. We recommend using the loud-
speaker on power circuits with circuit breakers with C characteristic.
