SEE WATER, INC.
Troubleshooting:
Caution: Before checking electrical connections within the control or
attempting to replace any components, turn off all branch circuits supplying
power to the main control panel.
Pump control does not activate the pump or pump does not run
•
Verify polarity is correct.
•
Confirm all connections are tight and secure.
•
White plastic case must be kept clean. Clean with house hold rubbing
alcohol and rag.
•
Keep control 1” - 2” clear of any metallic material. Mount to PVC pipe
or if mounted to metal pipe, make sure to mount with See Water quick
mount PVC bracket.
Alarm will NOT activate
•
Confirm separate 120VAC power to circuit board TS1-1 and TS1-2.
Power can be jumpered from incoming voltage if needed.
•
Check for any visual damage to optic or stainless steel sensor on the
Liquid Smart® Sensor.
Preventive Maintenance
•
The Oil Smart® Pump Switch and Liquid Smart® Sensor must be kept
clean. If the switches are submerged during install or maintenance,
clean the white plastic case with rubbing alcohol. Consistent inspection
and preventive maintenance ensures longevity and proper operation of
components.
Three Phase Duplex Control Panel
Installation and Operation Manual
OSD3P-30XX
Additional Panel Options:
24 - Pump Exerciser
•
Auto cycles pumps daily, weekly or monthly.
Run Time Options:
•
Position A: 50ms (DIP Switch 1,2, and 3)
•
Position B: 100ms
•
Position C: 4s
•
Position D: 8s
28
3R
6P
AF
AH
C
CCD
DPR
ETD
LAD/
LAW
MD
PM
PX
SFD
ST
= Power On Dry Contact
= Painted Steel Enclosure
= Upgraded Enclosure (NEMA 6P Rated); Removes
Buzzer and Beacon
= Alarm Flasher
= Anti-Condensation Heater
= Additional Cord Length Greater Than 20’*
= Cycle Counter w/ LCD Display and Reset
= Dry Contact for Pump Run
= Elapsed Time Meter w/ LCD Display and Reset
= Lightning Secondary Surge Arrestor
= Main Disconnect
= Phase Monitoring
= Pump Portal® Wireless Remote Panel Control and
System Monitoring
= Seal Failure Circuit w/ Indicator Lights
= Upgraded Enclosure (Stainless Steel)
*Additional cord length greater than 20’. Specify after
C. Example: (OSD3P-3021-C50). Indicates 50’ cord
lengths for all components.
Warranty:
See Water, Inc. warrants that products of its manufacture are
free from defects in material and workmanship for a period of 5
years from the date of purchase. This date shall be determined
by the date on the invoice and the serial number on the product.
Replacement of the product is at the discretion of See Water,
Inc. This warranty is valid when the product is installed in
compliance with the manufacturer’s installation instructions.
The manufacturer’s obligation under this warranty shall be
limited to the repair or replacement of any parts found by
the manufacturer to be defective, provided that the product
is returned to See Water, Inc.’s factory, postage prepaid with
proof of original purchase included.
The manufacturer of this warranty shall not be liable under this
warranty if the product has not been properly installed; any
alterations/additions/changes to the product will result in a void
warranty. Failure to properly install and test this product can
result in personal injury or equipment malfunction.
See Water, Inc. shall not be liable for any loss, damage or
expenses from installation or use of its products.
www.seewaterinc.com
951.487.8073 • 888.733.9283 • [email protected]
22220 Opportunity Way, Suite 101 • Riverside, CA 92518
Page 3-3
IM 804 REV. 02/20
