5
Storing (saving) preset points:
Using a PTZ controller, aim the camera at the desired subject and adjust
zoom if desired. To store the preset in the camera, consult the manual for the
specific PTZ controller you are using for how to store a preset. Sometimes
storing a preset is referred to as “writing”, “saving”, “setting” or some other
similar term. For instance, on a SecurityTronix ST-PTZMINI-KB controller,
the button sequence to STORE preset 1 on a camera is:
Press
“SET”
, press
“1”
, press
“PRE”
.
Calling preset points:
Normally, “calling” a preset will cause the camera to move to the position it
was at when that preset number was stored. There are a few exceptions,
such as the preset numbers which are reserved for special functions, as
listed in the table below. To “CALL” a preset in the camera, consult the
manual for the specific PTZ controller you are using for how to call a preset.
For instance, on a SecurityTronix ST-PTZMINI-KB controller, the button
sequence to CALL preset 1 on a camera is:
Press
“1”
, press
“PRE”
.
Preset point function table:
Call Preset 95
Enter the On-Screen menu.
Call Preset 82
Auto Cruise
Call Preset 83
Clear all presets
Call Preset 84
Start Pattern scan 1
Call Preset 85
Start Pattern scan 2
Call Preset 86
Start Pattern scan 3
Call Preset 87
Start Pattern scan 4
Call Preset 96
360-degree scan with 90° stops
Call Preset 97
Scan between two presets
Call Preset 98
Presets cruise
Call Preset 99
360 degree continuous scan
