Security Tronix ST-DVR7204G, User Manual

Page: 24 / 89

v2.0 11/8/11 24
f. DELAY – Period during which the alarm sounds after the alarm input returns to standby
status. Set a delay in the range of 10 to 300 seconds.
g. RECORDING CHANNEL – Select one or multiple recording channels for the video signal
when the alarm is activated.
h. TOUR – Upon a video loss or other alarm event the monitor will display a single window
beginning with the channel on which the alarm took place. If desired, additional single
windows per channel will sequence. The sequence interval is set by going to
Main Menu ,
clicking on the System icon, clicking on the Tou r icon and entering the interval period in
seconds.
i. PTZ ACTIVATION – In the event of a video loss or other alarm a PTZ camera can be
activated and set to automatically pan and or cruise among pre-determined spots. By
clicking on SET a PTZ Activation screen appears.
For each PTZ camera select the type of PTZ function desired from the drop-down menu.
When done, click
OK . Note for PTZ activation to work, the PTZ camera has to be
configured by going to Main Menu , clicking the System icon, and clicking the PTZ Config
icon and entering the settings. Once done, the PTZ’s presets, pattern or cruise settings
must be created. This is done by calling up the
PTZ Control through the Short-cut Menu .
j. DELAY - Once the alarm stops the recording will continue for a set period of 10 to 300
seconds then stop.
k. SHOW MESSAGE – If the checkbox is highlighted an Alarm Status screen will appear on
the monitor when a video loss event occurs.
l. BUZZER – If the checkbox is highlighted a beep will be heard when a video loss event
occurs.
m. SEND EMAIL – If the checkbox is highlighted an email will be automatically sent to a
designated individual when a video loss event occurs. Go to Main Menu , click the
System icon and then click the NetService icon to enter the desired email setting.
n. After all selections are made click OK .
7. PLAYBACK OPERATION
a. Playback is accessed in one of three ways: (i) by clicking the right mouse button to
display the Short-cut Menu and selecting PlayBack , (ii) by going to Main Menu , clicking
the Record icon then clicking the PlayBack icon , or (iii) pressing the Play button on the
DVR’s front panel . Upon doing so a PlayBack/File Search screen similar to the one
below will appear.