T/SED900/031A
22
nd
August 2018
Back of Touch Bar
Touch Bar
Side view of assembly
Figure 1
Figure 2
Side view of assembly
Back of Touch Bar
Touch Bar
with the 3 fixing screws.
Cut the fixing bolts to suit door thickness, for the Digital Mechanical Lock, allowing at least 4/5
threads to screw into the lock case.
Locate the rubber seal behind the Digital Lock and using the fixing bolts and cup washers secure
the top and bottom of the Lock to the door.
Before final tightening ensure the lock is vertical and test mechanism to ensure that it is moving
freely.
Positioning of Spindle in the Brass Bush
For Left handed applications the spindle should be fully rotated anti-
clockwise prior to locating it in to the brass bush.
For Right handed applications the spindle should be fully rotated clockwise
prior to locating it in to the brass bush.
Touch Bar
Position and secure the Touch Bar Support Plate to the internal face of the
door.
Prepare Touch Bar for installation as per separate Installation Instructions.
Before
securing the rest of the Touch Bar to door follow the steps below.
FOR LEFT HANDED
installation the Brass Bush must be located in the Touch Bar as seen in Figure 1.
FOR RIGHT HANDED
installation the Brass Bush must be located in the Touch Bar as seen in Figure 2.
Secure Touch Bar mechanism to the Support Plate and check all parts are functioning correctly before
closing the door.
Passage Function
This allows Free Entry Mode; the outside lever will retract the latch bolt
without the use of the Code.
To enable the feature follow the steps below:
Enter the correct code
Press the handle down to 25-75⁰ and push the “F” button
Return the handle to the horizontal position and release the “F”
button
To cancel Free Entry Mode:
Press the “C” button and press the handle down to 25-75⁰
Return the handle to the horizontal position and release the “C”
button
75
⁰
25
⁰
Spindle
Spindle
Brass
Bush
Brass
Bush
Spindle
Spindle
