Resetting to default
The lock can be reset to default by pressing the reset button on the back of the interior assembly.
•
Open the battery compartment
•
Raise the latch to release the interior assembly from the mounting plate
•
Slide away from the spindle
•
Rotate the integrated door sensor arm to access the reset hole
•
Using a paper clip press and hold the reset button inside the reset hole for approximately 5
seconds. You will hear
“Reset to Factory Default”
•
All user codes and fingerprints will be deleted and the Administrator code will be reset to
123456
Arming the system
After locking the door, press
then
0
button
within 10 seconds. This will arm the system by turning on
all notifications for all connected SECURAM devices.
Repeated invalid code entry
–
Lock Out Mode
After entering 5 invalid codes, the touchpad is disabled for 3 minutes
–
Lock out mode. Even though the
touchpad is disabled, fingerprints or the app can still open the lock.
Low Battery
Low battery voltage: 4.6 to 5.0 volts
Under a low battery condition, the SECURAM Touch will provide a low battery warning upon code or
fingerprint entry. The lock will unlock with the voice warning
“Low Battery”,
and the low battery
indicator flashes red. Please change battery.
NOTE: Lock programming cannot be performed with a low battery.
