detection;
“Enable” Reverse display ■ indicates that the motion detection function is enabled, and
the corresponding settings can be made after being enabled;
“Sensitivity”The alarm sensitivity has the lowest, low, medium, high, higher, and the
highest six files are available. The higher the sensitivity, the easier it is to trigger the alarm,
and the false alarm rate will also increase;
Note: Sensitivity settings are only available in the motion detection function of analog
channel in hybrid mode / full analog mode.
“Region”Click Settings to enter the region setting page. The region is divided into PAL
22X18, the red region is the motion detection arming area, and the black region is the
non-defending area, as shown in the following figure. Hold down the left mouse button
and draw the setting area (the default all areas are selected as the monitoring region).
Note: Region settings are only available in the motion detection function of analog
channel in hybrid mode / full analog mode.
“Period”:The recorder will trigger the motion detection alarm signal within the set time
range. It can be set by week, or it can be set uniformly, and four time periods can be set
every day. Check the check box before the time period ■, the set time will take effect.
“Interval” During the set interval time, the motion detection alarm is triggered multiple
times to output only one alarm signal;
“Record Delay”After setting the motion detection alarm, the recorder will continue to
detect the time period of the recording, and the setting range is 10~300 seconds.
“Recording channel”: Set the channel number of the linked recording when the motion
detection alarm is triggered (can be checked); when the alarm occurs, the recorder will
record the selected channel;
