1. I
NTRODUCTION
Unpacking
Unpack the product carefully and make sure that all pertinent parts like mounting
screws (and dust covers, if included) are put aside so they will not be lost.
Check the contents against the packing list. If any of the contents listed are missing,
please contact
S
ECU
C
ONTROL
immediately (see contact information at the rear cover
of this manual).
Examine the product for any shipping damage. If the product is damaged, notify
the shipping company without delay. Only the consignee (the person or company
receiving the unit) can file a claim against the carrier for shipping damage.
Part Number and Manufacturing Date Location
Part number and manufacturing date are stated on a label on the right side of the test
block or test plug.
Safety Symbols
The following symbols are located on different parts of the equipment and in this
manual:
Paragraphs marked with this symbol contain information which,
if not properly followed, may cause damage to the equipment
and/or installation.
Paragraphs marked with this symbol contain information which,
if not properly followed, may cause personal injury or even
death.
General Safety Instructions
Installation and operation of the products described in this manual is only to be per-
formed by personnel that has been trained or is knowledgeable in substation protec-
tion, automation and control.
This instruction manual is an integral part of the scope of delivery and provides basic
instructions for installation and operation of the equipment here described. Shall ad-
ditional information be needed, please contact
S
ECU
C
ONTROL
at any of the addresses
provided on the rear cover of this document.
Do not disassemble the test block or test plug. Correct alignment of internal parts is
critical in order to provide insulation and arch-avoidance.
The warranty will be void if the test block or test plug is disassembled (or otherwise
handled inappropriately). SecuControl does not assume responsibility for any dam-
2