SECO-LARM Electric Door Strike with Vertical Adjustment
8
SECO-LARM U.S.A., Inc.
Door Strikes
Fail-safe or fail-secure
available
Deadbolts
Fail-safe or fail-secure
available
Magnetic Locks
80, 300, 600, and 1200-lb
holding force available
Shear Lock
1500-lb holding force
Fail-safe operation
SD-995C / SD-994C shown SD-997B-GBQ shown
E-941SA-1200 shown
SD-993B-SS
Troubleshooting:
Also Available from
SECO-LARM
®
:
Electric strike does not activate
•
Dismount the strike and check that the electrical connector is
connected properly.
•
Ensure the electrical connector is connected to a 12 or 24VDC
source.
•
Use a multimeter to test that the strike is receiving the proper
voltage and amperage. If it is not, it may be necessary to use
heavier gauge wires, or increase the output of the power supply.
•
Make sure the activation device (keypad or push-button switch) is
working properly.
Door does not open when the
electric strike is activated
•
Check that the door latch is operating properly, and replace if
necessary.
•
The position of the electric strike may need to be adjusted by
moving it or adding washers or shims.
Strike makes a buzzing sound
•
Use DC power supply instead of AC power
NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM
reserves the right to change specifications without notice. SECO-LARM is not responsible for misprints. Trademarks are the
property of SECO-LARM U.S.A., Inc. or their respective owners.
Copyright © 2016 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or
in part, without the written permission of SECO-LARM.
LIMITED WARRANTY:
This SECO-LARM product is warranted against defects in material and workmanship while used in
normal service for three (3) years from the date of sale to the original customer. SECO-LARM’s obligation is limited to the
repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is
void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration,
improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is
not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of
SECO
-
LARM and the purchaser’s exclusive remedy, shall be limited to the replacement or repair only, at SECO-LARM’s
option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property
damage of any kind to the purchaser or anyone else.
SECO-LARM
®
U.S.A., Inc
.
16842 Millikan Avenue, Irvine, CA 92606 Website: www.seco-larm.com
PITGW1
Phone: (949) 261-2999 | (800) 662-0800 Email: [email protected]
MI_SD-996C-xxVQ_160523.docx
