SECO-LARM No-Cut Door Strike
4
SECO-LARM U.S.A., Inc.
Connect the strike to a DC power supply.
Troubleshooting:
Door does not open when the
electric strike is activated
Dismount the strike and check that the wiring connector is
connected properly.
Ensure the wiring connector is connected to a 12 or 24VDC source.
Use a multimeter to test that the strike is receiving the proper
voltage and amperage. If it is not, it may be necessary to use
heavier gauge wires, or increase the output of the power supply.
Make sure the activation device (keypad or push-button switch) is
working properly.
Electric strike does not activate
Check that the door latch is operating properly, and replace if
necessary.
The position of the electric strike may need to be adjusted by
moving it or adding washers or shims.
Strike makes a buzzing sound
NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM
reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints.
Copyright © 2016 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or
in part, without the written permission of SECO-LARM.
LIMITED WARRANTY:
This SECO-LARM product is warranted against defects in material and workmanship while
used in normal service for three (3) years from the date of sale to the original customer. SECO-LARM’s obligation is limited
to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This
Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair
or alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such
equipment is not operating properly as a result of causes other than defects in material and workmanship. The sole
obligation of SECO
-
LARM and the purchaser’s exclusive remedy, shall be limited to the replacement or repair only, at
SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential
personal or property damage of any kind to the purchaser or anyone else.
SECO-LARM
®
U.S.A., Inc
.
16842 Millikan Avenue, Irvine, CA 92606 Website: www.seco-larm.com
PITGW1
Phone: (949) 261-2999 | (800) 662-0800 Email: [email protected]
MI_SD-993C-D3Q_160930.docx
Horizontal and Vertical Adjustment:
The keeper can be easily adjusted horizontally to account for various installation anomalies and
the vertically adjustable deadlatch ramp accommodates a wide range of lock types.
To adjust the keeper and/or the deadlatch ramp:
1.
Loosen the two keeper adjustment screws and/or the ramp adjustment screws.
2.
Move the keeper horizontally and/or the deadlatch ramp vertically to the desired position.
3.
Retighten the two keeper adjustment screws and/or the ramp adjustment screws.
Keeper Adjustment
Screws
Ramp Adjustment
Screws
