ENFORCER Mini PTZ Camera
10
SECO-LARM U.S.A., Inc.
Understanding and Operating Preset and Pattern Functions:
:
Standard Pelco-compatible controllers allow the camera operator to do several functions without going
through the full OSD menu, depending on the capabilities of the DVR to which the camera is connected.
The SECO-LARM series of DVRs allows operators to do the following via the "Dome Preset" menu:
Set the camera to remember multiple specific preset locations.
Tell the camera to go to a specific preset location.
Run certain preset functions, including patterns, frame scan, or preset cruise functions.
Change certain configuration patterns.
Programming the patterns, frame scan, preset cruise, and a detailed configuration of the PTZ camera
requires operators to use the OSD menu. See page 16 for more information.
This PTZ camera can be controlled by any DVR or keyboard controller which uses Pelco-compatible
protocols. When using non-SECO-LARM DVRs or when using keyboard controllers, the manuals for those
devices may include information on how to operate or program the PTZ camera.
To set or go to a preset location or use a preset function via a SECO-LARM DVR:
1.
Press the "Dome" button. The lower left corner of the screen will change from "REC" to "DOME" to
show the camera is in the Dome Control menu.
2.
Press the "1" button to go to the DOME PRESET menu.
3.
Use the UP, DOWN, LEFT, and RIGHT buttons to highlight your selection and press ENTER to confirm
your selection.
Note:
In most cases, only the GO function will work. Only the preset locations can be programmed via
the DOME PRESET menu. Other functions must be programmed using the OSD menu.
4.
Use the UP and DOWN arrows to switch between YES and NO. Navigate to YES, and then press the
ENTER button.
See page 12 for a list of preset functions.