3
2. What‘s in the box
Please check immediately to ensure that you have received the following articles:
• Cutting Plotter
• Cutting Plotter Stand (dismantled)
• Power Lead
• Knife Holder
• 3 Drag Knives
• USB connection lead
• Penholder and pens
• CD Rom with software, drivers and
Operating Guide
3. Setting up the Stand
Required tools: 1 x Phillips screwdriver, 2 x size 13
spanners
• Start by using the countersunk Phillips screws to
connect parts (a) and (b).
• Attach the two support plates (c) to the two upper
threaded bore holes (b) which are slightly displaced
outwards.
• Use Phillips screws to connect the strut (d) to the
central threaded bore holes.
• Turn the stand upside-down and use small Phillips
screws to connect (e) and (b).
• (Parts not shown in figure) Attach the roll holder to
e
a
the two support plates (c) using two dowel pins at both sides. To do so, attach the two dowel pins
• (Parts not shown in figure) Attach the roll holder to
• (Parts not shown in figure) Attach the roll holder to
on one side using the nuts provided. Then push both bars onto the dowel pins, and insert the do-
wel pins into the bars at the other end. Tighten the nuts provided to fix everything in place.
