Seca 703s, Instruction Manual And Guarantee

Page: 34 / 280

34 •
5.2 Fit column
1. Place the column on the weighing platform as
shown in the adjacent illustration:
– the display head points away from the
platform
– assembly bores for the measuring rod point
towards the weighing platform
2. Perform all the remaining assembly steps for the
column as described in the instructions for use for
the
seca 704/703
:
►
Screw column tight
►
Connect display cable
►
Connect the power supply cable to the
electronics box
3. Set up the scale as described in the instructions for
use for the
seca 704/703
.
4. Provide the power supply for the scale as de-
scribed in the instructions for use for the seca 704/
703
.
5.3 Fit measuring rod
1. Pull out the upper telescopic element as far as the
173 cm mark.
The assembly bores in the lower telescopic element
are exposed.
2. Align the measuring rod as shown in the adjacent
illustration.
3. Put a set screw in the upper bore of the measuring
rod.
4. Align a spacer sleeve as shown in the adjacent
illustration.
5. Put the spacer sleeve on the set screw.
6. Screw the measuring rod hand-tight to the column
using the upper set screw.
7. Repeat steps 3. to 6. for the lower set screw.
8. Tighten up both set screws firmly.
Assembly
bores
173 cm