Sebury sKey2, Instruction Manual

Page: 3 / 10

2.2 Installation Steps
2.3 Wiring Diagram
Read Adding card once ,read several user card continuously, finally read adding card once.
3
.
Administrator Card Operation
Wiring Diagram
Note:Type A Electronic lock refers to the electric unlock when power on, such as electric control
lock, electric lock.
Type B Electronic lock refers to the electric unlock when power off, such as magnetic lock,
electric bolt lock.
3.1 Add User Card
Read delete card once, read several user card continuously, finally read delete card once.
3.2 Delete User card
+ +
+
sKey2 Reader mode
sKey2 Standalone Acess Control mode
green
Card reader
White
red
Green White BrownYellow Blue Purple Orange Gray Red Black
Green White Brown Yellow Blue Red Black
black
-
- -
Access control special
power supply
Universal access controller
Magnetic switch
Class
A electric lock
Class B electric lock
Exit button
Alarm
PUSH
The door opening
time of the
machine is set to 0
(50mS)
50mS
D0 D1 D-IN OPEN NO COM NC ALARM- +12V GND D0 D1 LED BZ
PUSH +12V GND NO COM NC
①
Stick the punch sticker on the wall, drill Φ14mm hole for outlet and 4 Φ6mm installation holes
with expansion, then insert 4 expansion rubber bungs into the installation holes;
②
Screw out the anti-dropping screws under the side of the product with a screwdriver, take off
the bottom shell of the product, compare the opening position of the bottom shell, and fix the
bottom shell on the wall with 4 self-tapping screws;
③
According to the selected wiring diagram, cut the lead wire to the appropriate length, and cut
off the excess wire ends, connect the system wire through the wall or in the embedded box
according to the wiring diagram one by one, taking care not to connect wrong or short circuit,
otherwise the machine may be burn out. After checking correctly, power on shortly to test
whether the indicator is normal, and whether the buzzer beep, otherwise cut off the power
supply immediately, re-check whether the wiring is correct. After checking correctly, install the
product lid on the back shell on the wall, and fix it with anti-drop screws.
④
stick decoration piece on the anti-dropping screw position.
2/8