5
Section 1 – wing fillet installation
step 1
Locate the carbon tube and the wing to the fuselage. Locate the corresponding wing fillet to the
wing. Test fit the fillet and his alignment with the wing panel and fuselage. Once satisfied with the
fit, glue the wing fillet to the wing panel using medium CA. Use the glue carefully avoid over runs
onto the area to be covered with the material.
step 2
Use the covering iron carefully, at a medium temperature, to glue the cover material down around
the area of the fillet. Use caution while working around areas where the cover material overlaps to
prevent separating the covers.
step 3
Repeat steps 1 through 2 for the remaining wing panel and wing fillet.
Section 2 – ailerons installation
step 1
Trial fit the four aileron hinges, included in the hardware pack, in their place and verify the correct
position and alignment of the aileron with the wing panel.
