Seatex DPS 132, Installation Manual

Page: 90 / 108

Seatex DPS 132 Installation Manual, rev. 0 Appendix H – NMEA display
78
Power
Voltage: ............................................................................................................10.8 – 15.6 V DC
Power consumption:................................................................................................ 75 – 125 mA
Environmental Specifications
Enclosure protections:...........................................................................................................IP56
Temperature range: .....................................................................................................0 to +55
°
C
Storage temperature range: ..................................................................................... -30 to +70
°
C
NMEA Telegram Input
The NMEA telegrams listed below are input sentences processed and displayed as
information in the NMEA display.
The following telegrams may be used:
APB, BOD, BWC, BWR, BWW, DBT, DPT, GGA, GLL, HDG, HDT, MTW, MWV, RMA,
RMB, RMC, VBW, VHW, VTG, WCV, XTE, XTR, ZDA, ZTG
Installation
The NMEA display front is fully waterproof and can therefore be installed on deck or below.
The connections at the rear shall be protected from water ingress. The surface where the
display is going to be installed must be flat and even to within 0.5mm.
Mount the display as follows:
1.
Do not remove the protection film on the display before the installation is complete.
2. Carefully position the self-adhesive template on the surface where the display is to be
mounted.
3. Drill a small hole (pilot hole) first and then check the location on the other side of the
panel or bulkhead to confirm suitability.
4. Use the template to cut out a 85 mm (3.4'') hole for the display.
5. Drill the four screw holes using a 2.5 mm (0.1'') drill.
6. Secure the display using the four self-tapping screws provided. Ensure that the sealing
gasket is correctly located.
7. Apply the front panel corners.
Note Ensure that sockets without cable connections have the protection plug inserted.
FSP ref.: A11211400XRBRA0