Seatex DPS 132, Installation Manual

Page: 71 / 108

Seatex DPS 132 Installation Manual, rev. 0 Appendix D - DPS setup file
59
! HDOP LIMIT If HDOP exceeds this limit, no position or
! velocity fix is computed
! PDOP LIMIT
If PDOP exceeds this limit, no position or
! velocity fix is computed
! HEIGHT AID
See description below.
! AIDED STDV [m] Accuracy of height information.
! AIDED HEIGHT [m] Initial value for filtered height aiding. The value
! is the antenna height above the WGS 84 ellipsoid.
! DIFFCORR AGE LIM [s] Maximum age of corrections
! DIFFCORR RANGE LIM [km] Reference station outside this radius are ignored
! The maximum range limit is 10 000 km. If a range limit
! is set outside this limit, 10 000 km will be used.
!
! The parameter HEIGHT AID selects the height aiding mode :
! 0: No height aiding
! 1: Use value of AIDED HEIGHT as constant height
! Recommended ==> 2: Use automatic filtered height aiding. Initial height
! is selected from a preconfigured geoid model, normally
! STANAG 4294. Note that if the correspoindng file
! (Stan4294.GRD) is not found, HEIGHT AID mode 3 is used.
! 3: Use automatic filtered height aiding with AIDED Height
! as initial height.
!
[GPS]
ELEVATION MASK 10
HDOP LIMIT 4
PDOP LIMIT 100
HEIGHT AID 2
AIDED STDV 100.0
AIDED HEIGHT 0.0
DIFFCORR AGE LIM 90
DIFFCORR RANGE LIM 2000
! General GLONASS settings (ignored on DPS 100 and DPS 116 systems)
! Same syntax as for GPS settings, but prefixed with GLONASS_
[GLONASS]
GLONASS_ELEVATION MASK 7
GLONASS_HDOP LIMIT 4
GLONASS_PDOP LIMIT 100
GLONASS_HEIGHT AID 2
GLONASS_AIDED STDV 100.0
GLONASS_AIDED HEIGHT 0.0
GLONASS_DIFFCORR AGE LIM 90
GLONASS_DIFFCORR RANGE LIM 2000
!------------------------------- SBAS CONFIGURATION ---------------------------
! SBAS configuration parameters\n"\
! ENABLE LINK STATUS 1: enable sbas corrlink indicator in the TMS display 0: disable
! NAME A name identifying the sbas "link", e.g. SBAS
! DECODE PRN1 -1: decode data from all geo satellites, PRN2 is ignored XXX:decode data from geo satellite XXX
! DECODE PRN2 0: decode data from PRN1 only YYY:decode data from geo satellite YYY too
[SBAS]
SBASLINK ENABLE LINK STATUS 1
SBASLINK NAME SBAS
SBASLINK DECODE PRN1 -1
SBASLINK DECODE PRN2 0
!--------------------- DIFF CORR LINK INTERFACE AND DECODING ------------------*
! Stuff for RTCM and SCF decoding
! Comm parameters: nh:no handshake, sh:software handshake, hh:hardware handshake
! DCLNKx NAME A name identifying the link, e.g. SpotBeam
! DCLNKx TYPE options: SCF = Supercompressed format
! RTCM = RTCM Sc-104 v2.2 format
FSP ref.: A11211400XRBRA0