Seat Toledo 2019, Owner'S Manual, Page: 36 / 300

The essentials
When the service date has passed , a minus
sign is displayed in front of the number of kilo-
metres or days.
Vehicles with text messages :
Service since
--- km or --- days ago
will be shown on
the display.
Resetting service interval display
If the service was not carried out by a SEAT
dealership, the display can be reset as fol-
lows:
●
Switch off the ignition, press and hold the
button
0.0/SET
›››
Fig. 41
2
.
●
Switch ignition back on.
●
Release the button
0.0/SET
and press it
again for the next 20 seconds.
Note
●
The service message disappears after a
few seconds, when the engine is started or
when
OK/RESET
is pressed on the wind-
screen wiper lever, or
OK
on the multifunc-
tion steering wheel.
●
In vehicles with the LongLife system in
which the battery has been disconnected
for a long period of time, it is not possible to
calculate the date of the next service.
Therefore the service interval display may
not be correct. In this case, bear in mind the
maximum service intervals permitted
›››
 page 262 .
Cruise control
Operating the cruise control sys-
tem (CCS)*
Fig. 42
Left of the steering column: CCS
switch and controls.
●
Switching on the CCS: Move switch
›››
Fig. 42
1
to

. The system is on. If no
speed has been programmed, the system will
not control it.
●
Activate the CCS: Press button
›››
Fig. 42
2
in the

area. The current speed is
memorised and controlled.
●
Temporarily switching off the CCS: Move
switch
›››
Fig. 42
1
to

or push the
brake. The cruise control system is switched
off temporarily.
●
Reactivating the CCS: Press button
›››
Fig. 42
2
in

. The memorised speed is
saved and controlled again.
● Increasing stored speed during CCS regu-
lation: press button
2
in

. The vehicle
accelerates until the new stored speed.
●
Reducing stored speed during CCS regula-
tion: press button
2
in

to lower the
speed by 1 km/h (1 mph). Speed is reduced
until reaching the new stored speed.
●
Switching off the CCS: Move switch
›››
Fig. 42
1
to

. The system is disconnec-
ted and the memorised speed is deleted.
 ›››
in Cruise control operation on
page 218

›››
page 217
Warning lamps
Control and warning lamps
Red warning lamps

Notification central lamp: additional infor-
mation on the instrument panel display

Parking brake on
›››
page 200 .

Fault in the brake system
›››
page 200 .

Fault in the steering system
›››
page 209 .

Driver or passenger has not fastened seat
belt
›››
page 63 .
34