Seat Ateca 2018, Owner'S Manual

Page: 290 / 412

Driving
light up on the instrument panel, and the pro-
grammed speed and ACC status will be dis-
played
›››
Fig. 259 .
What ACC settings are possible?
●
Setting your speed
›››
page 288 .
●
Setting your distance
›››
page 288 .
●
Connecting and activating the ACC
›››
page 288 .
●
Disconnecting and deactivating the ACC
›››
page 288 .
●
Adjusting the default distance level at the
start of your journey
›››
page 288 .
●
Adjusting the driving profile
›››
page 289 .
●
Conditions in which the ACC does not re-
act
›››
page 289 .
Setting speed
To set your speed, move the third lever loca-
ted in position
1
upwards or downwards until
the desired speed is shown on the instrument
panel display. The speed adjustment is made
at 10 km/h (6 mph) intervals.
Once you are driving , if you wish to set the
current speed as the vehicle’s cruise speed
and activate the ACC, press the

›››
Fig. 262 button. If you wish to increase or
reduce speed by intervals of 1 km/h (0.6
mph), move the lever to position
2
›››
Fig. 261 or press the

button, respective-
ly.
The set speed can be changed when the ve-
hicle is stopped or during driving, as you like.
Any modification to the programmed speed
will be shown on the bottom left part of the
instrument panel display
›››
Fig. 259 .
Setting your distance level
To increase/reduce the distance level, press
the rocker switch towards the left/right
›››
Fig. 262
A
.
The instrument panel display shows the mod-
ification of the distance level. There are 5 dis-
tance levels to choose from. SEAT recom-
mends level 3. The set distance can be
changed when the vehicle is stopped or dur-
ing driving, as you like
›››
.
Connecting and activating the ACC
To connect and activate the ACC, the posi-
tion of the gearbox selector lever, the vehicle
speed and the position of the third level of the
ACC must all be taken into account.
●
With a manual transmission, the gearbox
selector lever must be in any gear except
first, and the speed must be higher than ap-
proximately 30 km/h. With an automatic
transmission, the gearbox selector lever must
be in position
D or S .
●
To activate the ACC, with the third lever in
position
1
press the

button or move the
third lever of the ACC to position
2
›››
Fig. 261 . At this point, the image of the
ACC on the instrument panel display will
switch to
Active mode
›››
Fig. 259 .
When the ACC function is active, the vehicle
travels at a set speed and distance from the
vehicle ahead. Both speed and distance can
be changed at any time.
Disconnecting and deactivating the ACC
To disconnect the ACC move the lever to the
0
position
›››
Fig. 261 (engaged). An
ACC
deactivated
message appears and the
function is totally deactivated.
If you do not wish to disconnect the ACC, just
to switch it temporarily to inactive mode
(Standby), move the third lever to position
3
›››
Fig. 261 or press the brake pedal.
It will also switch to inactive mode (Standby)
if the vehicle is stopped and the driver door is
opened.
Adjusting the default distance level at the
start of your journey
In wet road conditions, you should always set
a larger distance with regard to the vehicle in
front than when driving in dry conditions.
The following distances can be preselected:
●
Very short
●
Short
●
Media
288