Seat Ateca 2018, Owner'S Manual

Page: 291 / 412

Driver assistance systems
● Long
●
Very long
In the Easy Connect system you can adjust
the distance level that will be applied when
the ACC is connected using the

>
SET-
TINGS > Driver assistance
›››
 page 36 .
Changing the driving profile
In vehicles with SEAT Drive Profile , the driving
profile selected can have an influence on the
ACC’s acceleration and braking behaviour
›››
page 304 .
In vehicles without SEAT Drive Profile , the be-
haviour of the ACC can also be affected by
selecting any of the following drive profiles in
the Easy Connect system:
●
Normal
● Sport
●
Eco
●
Convenience
In this case, you should access the ACC set-
tings using the

>
SETTINGS > Driver
assistance > ACC
›››
 page 36 .
The following conditions may lead the
ACC not to react:
●
If the accelerator is pressed.
●
If there is no gear engaged.
● If the ESC is controlling.
●
If the driver is not wearing his/her seat belt.
●
If several brake lights of the vehicle or elec-
trically connected trailer are damaged.
● If the vehicle is reversing.
●
Driving faster than 210 km/h (130 mph).
Driver messages

ACC not available
The system can no longer continue to guar-
antee safe vehicle detection and will be de-
activated. The sensor has lost its setting or is
damaged. Take the vehicle to a specialised
workshop and have the fault repaired.

ACC and Front Assist: currently
not available. No sensor vision
This message will be displayed to the driver if
the radar sensor's vision is impaired due, for
example, to leaves, snow, heavy fog or dirt.
Clean the SEAT badge
›››
Fig. 260 .

ACC: currently not available.
Gradient too steep
The maximum road slope has been excee-
ded, hence safe ACC operation cannot be
guaranteed. The ACC cannot be switched
on.

ACC: only available in D, S or
M
Select the D/S or M position on the selector
lever.

ACC: parking brake applied
The ACC is deactivated if the parking brake is
applied. The ACC is available once again af-
ter the parking brake is released.
 ACC: currently not available.
Intervention of stability control
The message for the driver is displayed when
the electronic stability control (ESC) inter-
venes. In this case, the ACC is automatically
switched off.
 ACC: Take action!
The message for the driver is displayed if,
when the vehicle starts up on a hill with a mild
slope, the vehicle rolls back even although
the ACC is activated. Apply the brake to stop
the vehicle from moving/colliding with anoth-
er vehicle.

ACC: speed limit
The message for the driver is displayed if, in
vehicles with manual gearbox, the current
speed is too low for the ACC mode.
The speed to be stored must be at least
30 km/h (18 mph). The speed limiter switches
off if the speed falls below 20 km/h (12 mph).

ACC: available as of the 2nd
gear
»
289