Seat Ateca 2018, Owner'S Manual

Page: 155 / 412

Lights and visibility
Fog lights
Fig. 152
Instrument console: light panel.
The warning lamps

or

also show, on the
light switch or instrument panel, when the fog
lights are on.
●
Turn on the fog lights*

; pull the light
switch to the first point
›››
Fig. 152
1
, from
positions

,

or

.
●
Turn on the rear fog light

: completely pull
the light switch
2
from position

,

or

.
●
To switch off the fog lights, press the light
switch or turn it to position

.
Note
The rear fog light can dazzle drivers behind
you. You should use the rear fog light only
when visibility is very poor.
Fog lights with cornering light func-
tion*
The cornering light function is an additional
function to the dipped beam headlights to
improve lighting of the side of the road when
taking a sharp turn at low speed.
The cornering light function works when the
dipped beam headlights are already on and
it is enabled when driving at speeds below
approximately 40 km/h (25 mph).
Forward gear
●
If the steering wheel is turned to the right or
the right-hand turn signal switched on, the
right-hand fog lamp is gradually switched on.
●
If the steering wheel is turned to the left or
the left-hand turn signal switched on, the left-
hand fog lamp is gradually switched on.
●
After the turn, the cornering light function is
gradually switched off.
Reverse gear
●
When engaging the reverse gear, both fog
lights turn on.
“Coming home” function
This function may be connected/disconnec-
ted through the radio menu. The “Coming
Home” and/or “Leaving Home” delay time
may also be set (default: 30 sec).
Vehicle with halogen headlights
In the “Coming Home” function, the daytime
running lights (DRL), the rear side lights and
the licence plate lights are turned on.
Vehicle with full-LED headlights
In the “Coming Home” function, the dipped
beams, the daytime running lights (DRL), the
rear side lights, the number plate lights and
the courtesy lights in the rear view mirror
(Welcome Light) switch on.
Automatic* activation of “Coming Home”
For vehicles with a light and rain sensor (rota-
ry light switch in position

).
●
Switch off the engine and remove the key
from the ignition with the rotary light switch in
position

›››
 page 33 .
●
The automatic “Coming Home” function is
only active when the light sensor detects
darkness.
●
When the car door is opened, the “Coming
Home” lighting comes on.
Manual “Coming Home” activation
For vehicles with a light and rain sensor (rota-
ry light switch without position

).
»
153