144
Seats and storage
Multi-purpose mobile storage compartment* - Fitting and
removal
This storage compartment may only be placed in the central
area of the rear seat
Fig. 110 Mobile storage
compartment. Installa-
tion
Fig. 111 Mobile storage
compartment mounting
plate
Fitting mobile storage compartment
–
Fold down the small section of the rear seat backrest, in order
to access the large section of the backrest.
–
Fit the mobile storage compartment mounting plate
H
⇒
Fig. 111
from the inside of the vehicle, through the rear part
of the seat. It should be fitted between the backrest and the
seat, in the central seat area.
–
Push the plate until it clips the cushion frame. The rings of the
mobile storage compartment mounting plate appear at the front
of the seat.
–
If it is difficult to make the plate clip, tilt the rear backrest of the
large section forwards slightly and then lean the backrest back-
wards to make the fitting of the mobile storage compartment
onto the mounting plate easier.
–
Place the mobile storage compartment onto the foam of the
central seat.
–
Set both mounting pieces together
E
⇒
Fig. 110
, with both
mounting rings
G
⇒
Fig. 111
and press hard until both the
clips completely connect with the rings.
Removing mobile storage compartment
–
Pull each of the buttons
⇒
Fig. 110
F
on the clips (red buttons)
forwards, until they snap out of place.
–
Fold the larger seat down and remove the mobile storage com-
partment mounting plate.
