Seat 2014 LEON CUP RACER, Owner'S Manual

Page: 235 / 284

Fuses and bulbs
● Press the locking tabs to release the fuse
box cover
›››
Fig. 203 .
● Then lift the cover out.
● To fit the cover, place it on the fuse box.
Push the locking tabs down until they click
audibly into place.
CAUTION
● Always carefully remove the fuse box cov-
ers and refit them correctly to avoid problems
with your vehicle.
● Protect the fuse boxes when open to avoid
the entry of dust or humidity. Dirt and humid-
ity inside fuse boxes can cause damage to
the electrical system.
Note
In the vehicle, there are more fuses than
those indicated in this chapter. These should
only be changed by a specialised workshop.
Replacing a blown fuse
Fig. 204 Image of a blown fuse
Preparation
● Switch off the ignition, lights and all elec-
trical equipment.
●
Open the corresponding fuse box
›››
page 232 .
Identifying a blown fuse
A fuse is blown if its metal strip is ruptured
›››
Fig. 204 .
Point a lamp at the fuse. This will make it
easier to see if the fuse is blown.
To replace a fuse
●
Remove the fuse.
● Replace the blown fuse by one with an
identical amperage rating (same colour and
markings) and identical size
›››
.
● Replace the cover again or close the fuse
box lid.
CAUTION
If you replace a fuse with higher-rating fuse,
you could cause damage to another part of
the electrical system.
Bulbs
Changing a bulb
Changing bulbs requires a certain degree of
practical skill.
If you choose to change the engine compart-
ment lamps yourself, remember that it is a
dangerous area
›››
in Work in the engine
compartment on page 198 .
Always use identical bulbs with the same
designation. The name can be found on the
base of the bulb holder.
Depending on how equipped the vehicle is,
there are different sets of headlights and tail
lights:
●
Halogen headlights
● Full-LED main headlights*
● Rear bulb light
● LED rear light*
»
233
Tec
hnic
al s
pec
ific
ation
s
Adv
ic
e
Oper
ation
Saf
ety
The e
ssenti
al
s