Seat 2014 LEON CUP RACER, Owner'S Manual

Page: 232 / 284

Advice
Windscreen wipers service position
Fig. 199
Wipers in service position
The wiper arms can be raised when the wip-
ers are in service position
›››
Fig. 199 . To
place the windscreen wipers in the service
position, proceed as follows:
● The bonnet must be closed
›››
page 198 .
● Switch the ignition on and off.
● Press the windscreen wiper lever down-
wards briefly
4
›››

page 16
.
Before driving, always lower the wiper arms.
Using the windscreen wiper lever, the wind-
screen wiper arms return to their initial posi-
tion.
Lifting and returning windscreen wiper arms
● Place the wiper arms in the service position
›››
.
● Only hold the wiper arms at the point
where the blade is fixed.
CAUTION
● To prevent damage to the bonnet and the
wiper arms, only leave them in the service
position.
● Before driving, always lower the wiper
arms.
Changing windscreen wiper and
window washer blades
Fig. 200
Changing the windscreen wiper
blades
Fig. 201 Changing the rear wiper blade
The windscreen wiper blades are supplied as
standard with a layer of graphite. This layer is
responsible for ensuring that the wipe is si-
lent. If the graphite layer is damaged, the
noise of the water as it is wiped across the
windscreen will be louder.
Check the condition of the wiper blades regu-
larly.
If the wipers scrape across the glass
,
they should be changed if they are damaged,
or cleaned if they are dirty
›››
.
Damaged wiper blades should be replaced
immediately. These are available from quali-
fied workshops.
Raising/lowering windscreen wiper arms
For windscreen wipers, please note:
the wip-
er should be in service position before being
lowering
›››
page 230 .
When raising or lowering an arm, it should
only be held at the blade fastening point.
230