WARNINGS
• Do not exceed the posted speed limit.
• Do not use if the indicator band is exposed on any of your
SeaSucker’s pumps.
• Do not use if all of your rack’s vacuum mounts cannot
maintain a full vacuum seal for at least 4 hours at a time.
• Check the indicator band during use.
• Clean the mounting surface before attaching.
• Clean SeaSuckers before attaching.
• Clean and lubricate your SeaSuckers’ pumps regularly.
• Remove racks when not in use.
• Attach protective covers when not in use.
• Inspect housing screws regularly and retighten if
necessary.
• Inspect clamp screws regularly and retighten if necessary.
The Rack’s Responsibility
With all SeaSuckers fully engaged, the rack will securely hold
at speeds of up to 70 mph. The rack will indicate if the
SeaSuckers are not maintaining vacuum: the indicator band in
the pump of each SeaSucker will extend out and become
visible upon loss of vacuum. If you see the indicator band, you
must re-pump the SeaSucker before the rack can be safely
used again.
Your Responsibility
You must inspect the indicator bands on all SeaSuckers when
entering and exiting your vehicle. A quick glance will tell you if
the rack is at full power. If the indicator band is visible, you must
re-pump the SeaSucker before the rack can be used. If any of
your SeaSuckers do not hold vacuum for at least 4 hours, they
may need to be cleaned, repaired, or replaced. Your rack
comes with an extra SeaSucker vacuum pump; keep it with
your rack in case you accidentally damage one.
What’s in the Box
•
(2)
Front bar mounts with (2) 6
″
SeaSucker vacuum cups
attached
•
(2) Rear bar mounts with (1) 6
″
SeaSucker vacuum cup
attached
•
(2) Aluminum cross bars
•
(1) 5g Lube Tube (for vacuum pump maintenance)
•
(1) spare SeaSucker vacuum pump (for maintenance)
•
(1) 5/32 hex wrench (for assembly)
Please contact SeaSucker directly if any of these
components are missing or damaged.
READ THIS
BEFORE
USING YOUR
MONKEY BARS!
SeaSucker, LLC
Bradenton, Florida
www.SeaSucker.com
