6
. Feed motor leads into electronics controller.
DO NOT
tighten
wire nut at this time.
7.
Connect Red (+) and Black (–) motor leads to the positive
and negative controller terminals respectively. (See figure A.)
Torque screws to 25 in/lbs.
8
. Tighten wire retaining nut hand tight.
9.
Re-install controller rear cover and six cover screws.
10.
Take note of old decal number on old motor shell. Clean new
motor free of residue and affix new decals (‘Identification’ and
‘Caution Hot’) included with this kit onto the new motor shell.
11.
Re-connect power to DC Power Unit.
12.
BEFORE operating boat. Confirm proper operation of
steering system by turning steering wheel hard over to hard
over several times.
OLD MOTOR
BOTTOM PLATE
GASKET
APPLY SMALL AMOUNT
OF THREAD LOCKER TO
THESE THREADS
REPLACEMENT
MOTOR
INSTALL DECAL
HERE
INSTALL DECAL
HERE
Figure C. Replacement Motor Installation.
NOTICE
Ensure you match the part number
of the older decal with the newer
decal (DC1000, or DC2000).
CAUTION
DO NOT reverse motor polarity or
damage to unit may result.
INSTALLATION INSTRUCTIONS
Copy Part# 391249, Rev. C, 01/2014
Page 3 of 3
© 2006 Marine Canada Acquisition Inc. DBA SEASTAR SOLUTIONS 3831 No. 6 Road, Richmond, B.C. Canada V6V 1P6
Fax: 604.270.7172
Web: www.seastarsolutions.com
