26
WARNING
CAUTION
1.6 The garage door opener will automatically open the door again,then close the door .
2 Test the Safety Reversal System
3 ADVANCED SETTINGS
Option A The “OPEN” position force sensitivity
Without a properly installed safety reversal system, persons (particularly small children) could be SERIOUSLY
INJURED or KILLED by a closing garage door.
· Safety reversal system MUST be tested every month.
· After ANY adjustments are made, the safety reversal system MUST be tested. Door MUST reverse on contact
with 1-1/2" high (3.8 cm) object (or 2x4 laid
fl
at) on the
fl
oor.
2.1
With the door fully open, place a 1-1/2 inch (3.8 cm)
board (or a 2x4 laid
fl
at) on the
fl
oor, centered under the
garage door.
2.2 Press the remote control push button to close the door.
The door MUST reverse when it makes contact with the
board.
If the door stops and does not reverse on the obstruction, the travel needs to be adjusted (refer to Adjustment Step
3). Repeat the test. When the door reverses upon contact with the 1-1/2 inch board, remove the board and open/close
the door 3 or 4 times to test the adjustment. If the test continues to fail, call a trained door systems technician.
3.1A
Press and hold the
SETTING
Button
until the screen
show the number from
“
1
” to “
3
”.
3.2
Press and release the
DOWN
Button
and the screen
show the “
∪
”.
3.3A
Press and release the
SETTING
Button and
the screen
show the levels of the force
sensitivity.
3.4
Use the
UP
Bottom to increase the levels, press the
DOWN
Bottom decrease the levels . The screen
show
the number of the levels.
3.5A
Press and release the
SETTING
Button and
the screen is flashing “
｜｜
”. Adjustments is
Additional operator functions can be set using the advanced operator
fuctions.Parameters factory default settings can be restored .This programming
may only be carried out by a professional installer.
