INSTALLATION
IIC.
Electrical connection
Install according to national and local codes.
Carefully place dishwasher on its back to make electrical connections to the terminal
block. Turn power off at the fuse box. Extend power cord approximately 21” from the
left side of the opening, and 30” from the back wall, making sure the cord doesn’t
contact any moving parts.
Strip outer casing of electrical wire to expose 2.5" - 3" (65 - 76 mm) of inner wires, then
strip 1/2" (13 mm) casing from each wire. If plugging the dishwasher into an outlet,
contact customer service to order approved power cord accessory kit (
SGZPC001UC
).
Insert cord through a strain relief (not included) and install to strain relief plate. Attach
wires to terminal block (black –
L
(hot), white –
N
(neutral) & green –
G
(ground).
Unscrew terminal screws,
but don’t loosen or remove them as they may become
damaged
. Attach wires snugly,
but don’t overtighten
.
IID.
Water connection
Install according to national and local codes.
Carefully place dishwasher on its back to make water connections to the water inlet
valve. Use a 90º elbow fitting with Teflon tape as needed. Don’t overtighten.
702_58300000150187_ara_en_a