6
Installation Guide
S T E P 1
For safety reasons, the following should be
performed by 2 people. Carefully lift the bed
frame unit out of the shipping carton with the
top side facing downward.
S T E P 2 :
A S S E M B L E T H E B E D L E G S
For this step, you will need 4 bed legs (C), which
can be found in the accessories box. Turn each
bed leg (C) in a clockwise direction into the
threaded holes on the frame as shown. Repeat
the bed leg assembly for all 4 legs (C) provided.
S T E P 3
Remove and extend the power cord from
the frame.
S T E P 4
S T E P 5
Carefully rotate the base frame over so the top side
is facing upward.
MAKE SURE POWER CORDS DO NOT OBSTRUCT
ANY ADJUSTABLE BASE MECHANISMS.
Be careful not to rest the frame on its side. The weight
may damage the legs.
S T E P 8
Return bed to flat or level position.
S T E P 9 :
A T T A C H I N G T H E ‘ Q U I C K - S E T ’
M A T T R E S S R E T A I N E R B R A C K E T
If a headboard is to be installed, owners who have
purchased the optional Headboard Bracket Kit
continue on to step 10. If the Adjustable Base is to
be set up without a headboard, proceed to step 11.
DO NOT OVERTIGHTEN THE BED LEGS
S T E P 6
Plug the power cord into a grounded
electrical outlet.
N O T E :
For optimal safety, it is recommended that your
Adjustable Base is plugged into a surge protector (not
supplied with this Adjustable Base).
S T E P 7
Install batteries in remote control.
Test all functions on the remote control to
ensure all features are operational.
If the bed does not work, refer to
Troubleshooting on page 12.
N O T E :
I M P O R T A N T !
N O T E :
Fasten the ‘Quick-Set’ mattress retainer bracket
(B) to the foot of the bed base using the
‘Quick-Set’ slide method illustrated below.
Simply position the open ends of the Retainer
Bracket directly aligned with the ‘Loop’ Retainer
Anchors already installed to the foot of the base
surface. Slide the Retainer Bracket forward
allowing the open ends to glide into the loop.
