Sealey W1200T.V2, Instructions For Use

Page: 2 / 4

3. SPECIFICATION
Model No: ............................................................W1200T.V2
Maximum Lifting Capacity: ......................................... 1200kg
M inimum Wheel Ø: ................................................... 1000mm
M aximum Wheel Ø: .................................................. 1800mm
Roller Length: ............................................................. 490mm
M inimum Lifting Height: .................................................. 0mm
M aximum Lifting Height: ............................................. 760mm
O verall Size (W x D x H): ..................1300 x 1015 x 1500mm
4. ASSEMBLY LIST
5. ASSEMBLY
5.1. Refer to fig.1.
5.2.
Ensure that at least two people assemble the trolley.
5.3. Fit support frame (left) (5) to frame (12). Use bolt M16 x 110mm (14), flat washer 16mm (8), spring washer 16mm (9) and nut M16
(10).
5.4. Fit support tube (right) (15) to frame (12). Use bolt M16 x 110mm (14), flat washer 16mm (8), spring washer 16mm (9) and nut
M16 (10).
Note: Support frames are not handed. Ensure warning symbols are upwards and visible on trolley.
5.5. Fit braked castors (7) to frame (12). Use bolt M16 x 130mm (6), flat washer 16mm (8), spring washer 16mm (9) and nut M16 (10).
5.6. Fit unbraked castors (18) to end of support frame (left) (5) and support frame (right) (15). Use bolt M16 x 100mm (16), flat washer
16mm (8), spring washer 16mm (9) and nut M16 (10).
5.7. Fit roller tables (21). Get one person to hold table whilst other inserts mounting bar (17) with R clip hole end going in first. Secure
with R clips (11).
5.8. Fit roller table tension springs (23). Insert top end of spring into hole on end of roller tables (21) and the other end of the spring into
nut welded onto the inner edges of support frame (right) (15) and support frame (left) (5).
5.9. Fit wheel support (4) to frame (12) with handle to rear. Use pin (13) and R clip (11). Ensure R clips are on outside of frame as
shown in fig.1.
5.10. I nsert clamp support arm (1) into sliding tube (2), (remove hand wheel and washer (22) first), tighten clamp (3). Insert into wheel
support (4), tighten clamp on wheel support (4).
5.11. Insert handles (19 and 20) into sockets shown in fig.1.
5.12.
5.13.
5.14.
5.15.
Part Description Quantity
1 Clamp support arm 1
2 Sliding tube 1
3 Adjustment clamp 2
4 W heel support 1
5 Support frame (left) 1
6 B olt M16x130mm 2
7 Braked castor 2
8 F lat washer 16mm 6
9 S pring washer 16mm 6
10 N ut M16 6
11 R clip 4
12 Frame 1
13 P in 2
14 B olt M16x110mm 2
15 Support frame (right) 1
16 B olt M16x100mm 2
17 Mounting bar 2
18 Castor 2
19 H andle 1
20 H andle 1
21 Roller table 2
22 H an washer 1
23 Spring 2
Fig.1
W1200T.V2| Issue 3(I) 23/08/16 Original Language Version
© Jack Sealey Limited