instructions for
stud extractor set
model no:
Vs7233.V2
thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. saFetY
8
do Not
use the stud extractor set for any purpose other than for which it is designed.
9
Keep the kit free from dirt and grime.
9
ensure your work area is tidy and free from hazards.
9
ensure the correct sizes of guide and drill are used to avoid injury and damage to the set.
WarNING:
the warnings, cautions and instructions discussed in this instruction manual cannot cover all possible conditions and
situations that may occur. it must be understood that common sense and caution are factors which cannot be built into this product,
but must be applied by
the operator.
2. INtroductIoN
suitable for the removal of broken studs and bolts. supplied with centring pilots for Ø4.75-9.5mm studs, drills, extractor shafts and
nuts. ideal for engine manifold studs.
3. coNteNts
drill Bits: 3.2, 4.8, 6.4, 8, 8.7mm (stud range - 4.75 - 9.5mm)
4. sIze GuIde chart
Vs7233.V2 issue1 01/02/18
Original Language Version
© Jack sealey limited
refer to
instruction
manual
Wear protective
gloves
Wear eye
protection
stud size
4.0
4.75
4.75
4.75
6.1
7.2
7.2
7.2
9.0
9.75
12
15
Guide size
B1
B2
B3
B4
B5
B6
B7
B8
B9
B10
-
-
Guide ext. Ø
6.0
8.0
9.0
10.0
10.0
11.0
12.0
13.0
13.0
14.0
-
-
drill to use
3.2
3.2
3.2
3.2
4.8
4.8
4.8
4.8
6.4
6.4
8.0
8.7
Pin to use
Pin 1
Pin 1
Pin 1
Pin 1
Pin 2
Pin 2
Pin 2
Pin 2
Pin 3
Pin 3
Pin 4
Pin 5
Hex extractor
d1
d1
d1
d1
d2
d2
d2
d2
d3
d3
d4
d5
