2. introdUction
min./max. Working Height: 276/435mm. Capacity: 4tonne per pair. Ratchet type axle stand with cast iron support post and tough steel plate
welded base. Angled teeth in post prevent accidental release of load - the more weight applied, the tighter the post is locked. Sold in pairs.
3. SpecificAtion
model no’s: ................................................VS2002HV/Bl/oR
Capacity each: ......................................... 2 tonnes (2000 kg)
Capacity pair ............................................ 4 tonnes (4000 kg)
minimum Working Height ........................................... 276mm
maximum Working Height .......................................... 435mm
4. ASSeMBly
4.1.
Insert the centre column into the base frame and stand (fig.1).
4.2.
ensure the toothed side of column will engage with the locking lever mechanism (fig.2).
4.3.
Bend in locking tab using a punch or similar and a hammer (fig.3).
4.4.
Check the base frame and stand is in good condition and has not suffered damage during transit.
5. operAtion
5.1.
Refer to manufactures instructions for recommended jacking/support points.
5.2.
Check to ensure jacking/support points are in good condition. Position the stands beneath their
support points.
5.3.
To adjust the stands: Hold the control lever up while lifting the centre column to required height.
Push the control lever down to lock the pawl into the central column teeth (fig.1 and fig.2).
WArninG! enSUre pAWl iS fUlly enGAGed WitH teetH.
5.4.
Carefully and slowly lower vehicle onto stands. ensure load bearing points sit in the centre of the
saddles and that the stands are stable. Also ensure that there are no objects or persons that
could impede the safe lowering of the vehicle onto the stands.
▲
dAnGer!
You must follow instructions carefully and ensure you
do not
load the stands off centre. Failure to adhere to these
warnings may cause damage, injury or loss of life!
5.5.
Insert the locking pin to store the stands in their lowest position.
6. MAintenAnce
6.1.
Before each use, check that stands and stand welds are not cracked and that there are no missing or damaged parts.
6.2.
Any suspect axle stands must be removed from service immediately.
6.3.
due to the potential hazards associated with stands, do not misuse, or make any modification to, the stands or components.
6.4.
It is the responsibility of the owner to ensure that the operator has read these instructions together with the safety features on the side
of the stand and that the operator is aware of the stand uses and limitations.
fig.1
fig.3
Sealey Group, Kempson Way, Suffolk Business park, Bury St edmunds, Suffolk. ip32 7Ar
01284 757500
01284 703534
www.sealey.co.uk
enVironMent protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important
: no liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
fig.2
Original Language Version
© Jack Sealey limited
VS2002HV, Bl,oR Issue 1 31/05/18
