5. assembly
5.1.
The Host is wrist mountable by means of a separate wristband. Your phone can be mounted to the host by means of the mobile phone
holder.
6. oPeRation
8
do not
use excessive force to insert or retrieve probe from the equipment or areas under inspection.
8
do not
use the probe to push against objects or to clear a path. This instrument is for remote viewing only.
8
do not
bend any part of the shaft tighter than a 130mm diameter.
8
do not
insert the probe and tip into locations where the temperature is greater than 55°C.
8
do not
vibrate, bang, or drop your bore scope. It is not shock resistant.
6.1.
tuRning the host on and off
6.1.1.
To turn on, hold in on/off button (fig.5) until on/off indicator illuminates red (fig.2).
6.1.2.
To turn off, hold in on/off button (fig.5) until on/off indicator light goes out (fig.2).
6.2.
connecting to the aPP (fig.7)
6.2.1.
Make sure you have downloaded the app first. The QR code below will take you directly to the app (fig.6).
6.2.2.
To turn on the wifi, on the Host, press wifi on/off button (fig.5) The wifi signal indicator will flash green when trying to connect to the
phone. It will show a steady green when the device is ready to connect to the phone, and it will stay a steady green when it is visible
to the phone or connected to the phone.
note:
The wifi password is “00000000”.
6.2.3.
Connect to the Host’s wifi as you normally would for your smart-phones operating system.
6.2.4.
After you have connected your phone to the Host’s wifi, open the app.
7. maintenance
7.1.
If the device is not used, it should be stored in a dry place, away from children.
7.2.
If the cable is damaged, or there is a defect with the Borescope contact supplier.
fig.4
fig.7
fig.5
fig.6
Original Language Version
© Jack Sealey Limited
VS01W Issue 1 04/09/19
