INSTRUCTIONS FOR:
DIGITAL TORQUE ADAPTOR
WITH ANGLE FUNCTION 1/2”Sq.Dr. 20 - 200Nm
MODEL No:
STW291
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS
AND CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE
TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP
INSTRUCTIONS SAFE FOR FUTURE USE.
Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these
instructions and properly maintained, give you years of trouble free performance.
1. SAFETY INSTRUCTIONS
3. SPECIFICATION
2. INTRODUCTION
4. KEYPAD CONTROL FUNCTIONS
Designed for use with a standard ratchet or breaker bar. Ideal
for work around the engine bay and the tightening of wheel
nuts to factory specifications. Large LCD display with LED/
audible alarm indicating achieved and target torque levels.
Selectable readings in Nm, lb.ft, lb.in or kg.m. Accurate to
±2% of stated capacity and operates in either direction.
Features angle mode, eliminating the need for
angle gauges and protractors providing the most accurate
and fastest way to measure torque plus angle tightening
sequences. Will also accumulate angle measurement when
multiple turns are required, ideal for use where access is
restricted. Includes auto shut off. Supplied with test certificate
and storage case.
STW291 Issue No.1 28/06/12
Original Language Version
© Jack Sealey Limited
WARNING! DO NOT
use the digital torque adaptor if
damaged or thought to be faulty.
DO NOT
apply force to the adaptor when the power is
off. Always turn the adaptor on before using it otherwise
the adaptor will be damaged.
DO NOT
turn off the torque adaptor while torque force is
being applied.
DO NOT
exceed the permitted maximum torque value
for this torque adaptor. To do so will cause it to break.
DO NOT
subject the 1/2” connectors on the top and
bottom of the adaptor to any force other than a rotational
one.
Ensure that all components including all adaptors,
extensions, drivers and sockets are rated to match or
exceed the torque being applied.
Observe all equipment, system and manufacturer’s
warnings, cautions and procedures when using this
torque adaptor.
Use the correct size socket for the fastener.
DO NOT
use sockets showing wear or cracks.
Check that the torque adaptor capacity matches or
exceeds each application before proceeding.
Ensure all workshop safety rules, regulations, and
conditions are complied with when using this digital
torque adaptor.
Maintain correct balance and footing. Ensure the floor is
not slippery and wear non-slip shoes.
Keep children and unauthorised persons away from the
working area.
DO NOT
press, pressure, or damage the LCD display.
DO NOT
use the torque adaptor near strong magnetic
fields .
DO NOT
subject the digital torque adaptor to excessive
force or shocks.
DO NOT
drop or throw the digital torque adaptor.
DO NOT
leave the digital torque adaptor in any place
exposed to excessive heat, humidity or direct sunlight.
DO NOT
use organic solvents such as alcohol or
thinners to clean the digital torque adaptor.
DO NOT
submerge the digital torque adapter in water or
any other liquid.
DO NOT
disassemble the digital torque adaptor.
To ensure accurate measurement periodic re-calibration
is necessary.
After use clean with a soft dry cloth and store in a safe,
dry, childproof location.
Model No: STW291
Drive:
“1/2””Sq”
Length:
100mm
Range:
20-200Nm(15-147.5lb.ft, 354-1770lb.in)
Battery:
2 x CR2032 (Supplied)
