Original Language Version
© Jack Sealey Limited
5. asseMblY
step 1:
In the following order put flat washer Ø16, wheel spacer, second flat washer Ø16, tyre, third flat washer Ø16 on the end of wheel axle.
Insert the cotter pin Ø4x40 into the small hole on the axle and bend to secure. Rotate the wheel so that the hole on the inside of the wheel is
aligned with the hole on the axle, then Insert drive pin Ø6x45 and lock it.
step 2:
In the following order put flat washer Ø16, wheel spacer, second flat washer Ø16, Tire, third flat washer Ø16 on the end of wheel axle.
Insert the cotter pin Ø4x40 into the small hole on the axle and bend
to secure.
step 3:
Insert the hex bolt M6x50 after aligning the hole on the flat end of hitch tongue (place on top) with the one at the middle of crossover
tube.
Connect using a big flat washer Ø6 and nylon lock nut M6. Tighten fasteners securely.
step 4:
Attach the braces on each side of hitch tongue using bolt M6x45 and nylon lock nut M6. Loosely tighten.
step 5:
Attach the gauge and lever assembly to the middle of the hitch tongue using two hex bolts M8x45 and nylon lock nuts.
S
PB80T.V2 | Issue:1 11/11/19
step2
step3
step4
step5
step1
