6.3.
reMOVing/fitting tHe sanding Belt
6.3.1.
Slide the tension lever to the right to release belt tension (fig.9).
6.3.2.
Remove the sanding belt.
6.3.3.
Place the replacement sanding belt over the drums (fig.10). Ensure that the belt is centred on the drums.
6.3.4.
Slide the tensioning lever to the left to tension the belt.
6.3.5.
Run the machine briefly to check that the belt is running true.
6.3.6.
If the belt runs toward the table, turn the tracking knob 1/4 turn clockwise and vice versa (fig.11).
6.3.7.
If the belt still runs out of true,
repeat 6.3.6. until correct.
6.4.
dust eXtractiOn
6.4.1.
A vacuum cleaner may be connected to the extraction port to reduce airborne dust (fig.12).
7. Maintenance
7.1.
no lubrication is required as all bearings are lubricated for life.
7.2.
Cleaning:
dO nOt
use abrasive or solvent cleaners; clean with a damp
soapy cloth only.
7.3.
nOte:
even if coupled to a vacuum extraction system, dust is likely
to collect in the recess in the table. Periodic cleaning is necessary to
maintain the performance of the machine
sealey group, Kempson Way, suffolk Business park, Bury st edmunds, suffolk. ip32 7ar
01284 757500
01284 703534
www.sealey.co.uk
enVirOnMent prOtectiOn
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Weee regulatiOns
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important
: no liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
fig.9
fig.10
fig.11
fig.12
S
M1300 Issue 2 (HF) 24/05/18
Original Language Version
© Jack Sealey limited
