Others in the workplace should keep a safe distance from the drill, especially when it is in operation.
Keep the work area as childproof as possible by using padlocks and master switches.
Keep drill bits clean and sharp for best and safest performance. Follow the instructions for lubrication and changing accessories.
Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery and contain long hair.
Locate the drill in a suitable working area, keep area clean and tidy and free from unrelated materials. Ensure there is adequate lighting.
Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
Secure non-stable work piece with a clamp, vice or other adequate holding device.
Avoid unintentional starting.
DO NOT
force the drill to achieve a task it was not designed to perform.
DO NOT
allow untrained persons to operate the drill.
DO NOT
get the drill wet or use in damp or wet locations or areas where there is condensation.
DO NOT
operate the drill if damaged.
DO NOT
use drill in an area where paint fumes, solvents or flammable liquids pose a potential hazard. Keep flammable material away from
the drill when operating. Flammable waste, such as wiping or cleaning rags, must be placed in a closed metal container and disposed of correctly.
DO NOT
exceed the rated capacity of the drill.
DO NOT
operate the drill if any parts are missing as this may cause failure and/or personal injury.
DO NOT
leave the drill operating unattended.
DO NOT
operate the drill when you are tired, under the influence of alcohol, drugs or intoxicating medication.
DO NOT
pull the cable from the power supply.
When not in use switch the drill off, remove plug from the power supply and do not leave until the tool has come to a complete stop.
3. TECHNiCal SpECiFiCaTiON
2. DESCripTiON
The SDM30.V2 variable speed bench drill is suitable for light industrial, agricultural and woodworking applications. The drill is fitted with a
flip-up safety guard and “No Volt Release” switch which prevents accidental restart after a mains power interruption. A rack and pinion feed shaft
with preset depth control for repetitive work is also included. Work clamps are also available for this drill, contact your local Sealey dealer for
information.
Model
Chuck size (mm)
1.5 - 13
Spindle Nose Taper
MT2
Swing (mm)
208
Spindle Travel (mm)
50
Number of Speeds
5
Speed range (rpm)
580 - 2650
Spindle to Table - max. (mm)
200
Spindle to Base - max. (mm)
290
Working Table (mm)
158 x 160
Working Base (mm)
138 x 180
Overall Base (mm)
305 x 200
Column Diameter (mm)
46
Overall Height (mm)
Collar Diameter (mm)
580
40
Motor power (W - V)
Weight (kg)
15.6
4. CONTENT
4.1. package content
Unpack the parts listed below and check to ensure they are in good condition. Any queries must be reported to your dealer immediately.
Head Assembly
Base
Chuck and Key
Column with Flange
Feed Handles and Knobs (3)
Table and Bracket
3 Bolts and Washers
Safety Guard
Hex. Keys (2)
185 - 230
Spindle Centre to Column (mm)
104
input power (W - V)
350 - 230
Original Language Version
SDM30.V2 Issue: 1 - 30/06/11
SDM30.V2
