MIG GAS REGULATOR 1/2 GAUGE INDUSTRIAL
MODEL NO’s:
REG/MO.V2, REG/MT.V2
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9
Read the following instructions carefully before using the regulator, and keep them for future reference. The instructions provide all the
information necessary for correct use of the regulator, to avoid damage and danger.
SEALEY
will not be responsible for any damage occurring due to incorrect use of the regulator, or to modifications made to it. This gas
regulator is a delicate piece of workshop equipment. Failure to observe the following safety points will cause damage to the unit and will
invalidate your warranty.
9
Use regulator only for gas intended.
9
Use to designed pressure.
9
Check for damage and leaks at frequent intervals.
8
DO NOT
knock or jolt regulator.
8
DO NOT
use a regulator showing any signs of damage.
8
DO NOT
allow cylinders to become heated.
8
DO NOT
use pressure gauges that are damaged, not smooth in operation or not zeroing.
8
DO NOT
overtighten adjusting knob as this will damage diaphragm and void warranty.
8
DO NOT
oil the regulator.
WARNING!
Incorrect use of the regulator can cause serious damage. Users must be trained by specialist engineers.
WARNING!
The regulator must be treated as a precision instrument. Protect it from accidental knocks, dust, oil and other sources of dirt.
WARNING!
Do not use the regulator if it is not in perfect working condition
WARNING!
When you draw gas, the cylinder must be placed upright and protected from falling.
2. INTRODUCTION
i
T
op quality regulators made to ISO 2503. Industrial regulator fits CO2, Argon and CO2/Argon mix gas cylinders using adaptor. Suitable for
industrial size gas cylinders. Maximum operating pressure of 4bar.
3. SPECIFICATION
Model no’s..........................................................
REG/MO.V2
Argon/CO2 adaptor
.......................................................... yes
Cylinder type ............................................................industrial
Gauges ................................................................................1
M
ax. throughput (L/min)
.....................................................10
Safe working pressure ................................................230bar
The function of the regulator is to reduce and control the pressure of a gas. The regulator reduces the cylinder pressure at which the gas
is stored, to the pressure needed to use the gas. The pressure reducer has been designed so as to be used only and exclusively with the
type of gas and at the pressure which are shown by the markings stamped on the regulator body (refer to the markings key above).
WARNING!
To try and use the pressure reducer with types of gasses and pressures other than those indicated can be dangerous.
Refer to
instruction
manual
R
EG/MO.V2, REG/MT.V2 Issue:2 (H,F) 06/05/21
Original Language Version
© Jack Sealey Limited
KEY TO MARKINGS (stamped on regulator bodies)
Relevant
standard
'K' = Pressure
reducer class
Code for
gas type
Serial
number
Max inlet
pressure
EN ISO 2503
K1
N
170409 230BAR
Gas code 'N' = CO²
, Argon and CO
²
/Argon mix
Model no’s...........................................................
REG/MT.V2
Argon/CO2 adaptor
.......................................................... yes
Cylinder type ............................................................industrial
Gauges ................................................................................2
M
ax. throughput (L/min)
.....................................................10
Safe working pressure ................................................230bar