6.3.
HIGH PRESSURE HOSE
6.3.1.
Use the pressure washer only if the hose is completely uncoiled and extended. See fig.11.
6.4.
SWITCHING OFF
6.4.1.
Switch off the machine (fig.12.1).
6.4.2.
Turn off the water supply (fig.12.2).
6.4.3.
Unplug from the electrical socket (fig.12.3).
6.4.4.
Squeeze trigger to release any pressure left in the gun and hose (fig.12.4).
6.5.
T.S. TOTAL STOP
NOTE:
Total Stop, which stops the machine during the bypass phase. To start the water cleaner, it is therefore necessary to set the switch on
position (I) “ON”; after that press the pistol trigger: the Total Stop will start the machine and will stop it automatically when the trigger is
released. It is advisable to put on the safety of the pistol trigger whenever the machine is stopped, in order to avoid unintentional
starting.
6.5.1.
Any automatic start of the machine without pressing the gun trigger is attributable to air bubbles in the water or other similar
phenomena which
DO NOT
imply the existence of any defects in the machine.
8
DO NOT
leave the appliance unattended during the standby for more than 5 minutes. Contrarily, for the safety of the appliance it is
necessary to re-turn the switch into the (0) OFF position.
6.5.2.
Please check that the coupling of the high pressure hose with the appliance and the gun supplied as standard equipment made
correctly, that is to say without any water leak.
7. MAINTENANCE
7.1.
There are no user serviceable parts in this unit.
WARNING:
the machine shall be disconnected from its power source, by removing the plug from the socket-outlet, during cleaning or
maintenance.
WARNING: DO NOT
spray the appliance with water and
DO NOT
use detergents or aggressive solvents. The machine can be
damaged.
9
Clean the exterior part of the machine with a dry cloth.
7.2.
STORAGE
7.2.1.
Move the machine only by grasping the carrying handle.
7.2.2.
Before storing clean the filter (fig.13.1), dry the hose (fig.13.2), and clean the nozzle (fig.13.3).
7.2.3.
Store the appliance and the accessories in a frost safe room (fig.13.4).
8. TROUBLESHOOTING
8.1.
APPLIANCE DOES NOT WORK
8.1.1.
Check whether the voltage shown on the rating plate corresponds to that of the power source.
8.1.2.
Check the connector cable for damage. Appliance does not reach operational pressure
8.1.3.
Vent the appliance: allow the pump to operate without the high-pressure hose until water appears at the high-pressure outlet without
any more bubbles. Then reattach the high-pressure hose.
8.1.4.
Clean the strainer in the water connection.
8.1.5.
Clean the filter placed inside the hose coupling.
8.1.6.
Check the inlet water flow rate.
8.1.7.
Check all inlet pipes to the pump for leaks or blockage.
8.2.
STRONG PRESSURE FLUCTUATIONS
8.2.1.
Clean the high-pressure nozzle. Remove dirt from the nozzle hole with a needle and then rinse out with water from the front.
fig.11
fig.12
fig.13
P
W1601 Issue 1 20/11/2020
Original Language Version
© Jack Sealey Limited
