Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
PP5 Issue: 1 - 29/11/18
Original Language Version
© Jack Sealey Limited
Refer to instruction
manual
Wear eye
protection
INTEGRATED TEST LIGHT/VOLTMETER 3-48V
MODEL NO:
PP5
1. SAFETY
WARNING!
DO NOT
use test light with domestic 110-230Volt supplies. Only use with DC Voltages between 3 and 48Volts.
9
Observe standard workshop safety procedures when using the meter.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting. Keep tools and other items away from the engine and
ensure you can see the working parts of the engine clearly.
9
Maintain correct balance and footing. Ensure the floor is not slippery and wear non slip shoes.
9
Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery. Contain or tie back long hair.
9
Ensure extension leads and probes are kept clear of hot surfaces and rotating parts.
8
DO NOT
drape cables around neck or arms – danger of entanglement.
8
DO NOT
disassemble meter.
8
DO NOT
get test light wet or use in damp or wet locations or areas where there is condensation.
8
DO NOT
use the meter for any purpose other than for which it is designed.
8
DO NOT
use the meter if damaged.
9
When not in use place test in its case and store in a safe, dry, childproof location.
2. INTRODUCTION
LCD meter draws minute currents making this tool safe to use around delicate electronic components. With a range of 3-48V DC, this tool is
suitable for motorcycle, car and commercial applications. Includes interchangeable 65 & 175mm probes, leads and clips with Ø4mm banana
coupling.