4.7.
Pull the lever to engage the punch into the end of the brake pipe and continue to form the flare until a solid resistance is felt (Fig.5). Return
the handle to the original position to withdraw the punch. If the required flare calls for a second operation in Chart 1, slide the correct Op.2
punch in line with the brake pipe.operate the lever to complete the form of the flare.
Return the lever to the original position to withdraw the punch. Release the clamping screw and swing the clamp open and remove the
dies with the pipe. If necessary a gentle tap on a suitable surface will release the dies from the pipe.
Check the quality of the flare to ensure the pipe did not move during the flaring.
nb:
The punches and dies supplied for this tool must only be used with this equipment.
Sealey group, kempson Way, Suffolk business park, bury St edmunds, Suffolk. ip32 7ar
01284 757500
01284 703534
www.sealey.co.uk
enVirOnMent prOtectiOn
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important
: no liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Parts support is available for this product. To obtain a parts listing please log on to
www.sealey.co.uk, email [email protected] or telephone 01284 757500
fig.1
fig.2
fig.3
fig.4
fig.5
Sae cOnVeX
113º - 117º Din cOnVeX
Sae DOuble
tube
ØDia
Op.1
puncH
Die Set
tube
ØDia
Op.1
puncH
Die Set
tube
ØDia
Op.1
puncH
Op.2
puncH
Die Set
3/16 in
1
4.75-3/16
4.75mm
6
4.75d
3/16 in
1
7
4.75-3/16
1/4 in
2
1/4
6mm
6mm
6mm D
1/4 in
2
B
1/4
5/16 in
3
5/16
8mm
8mm
8mm D
5/16 in
3
8
5/16
3/8 in
4
3/8
10mm
10mm
10mm D
3/8 in
4
d
3/8
1/2 in
5
1/2
12mm
12mm
12mm D
1/2 in
5
9
1/2
6mm
2
6mm
4.75mm
1
7
4.75-3/16
8mm
3
8mm
6mm
2
B
6mm
10mm
4
10mm
8mm
3
8
8mm
12mm
5
12mm
10mm
4
d
10mm
12mm
5
9
12mm
P
FT/02.V3 | Issue 2 (HF) 08/03/18
Original Language Version
© Jack Sealey limited
