PC200SD110V.V2 Issue No.2 22/10/09
Original Language Version
INStruCtIoNS
INDUSTRIAL vAcUUm cLeANeR 20LTR
for moDel:
pc200SD110v.v2
thank you for purchasing a Sealey product. manufactured to a high standard this product will, if used according to these instructions and
properly maintained, give you years of trouble free performance.
IMPORTANT
:
pLeASe ReAD THeSe INSTRUcTIONS cAReFULLY. NOTe THe SAFe OpeRATIONAL ReQUIRemeNTS, WARNINGS, AND
cAUTIONS. USe THIS pRODUcT cORRecTLY, AND WITH cARe FOR THe pURpOSe FOR WHIcH IT IS INTeNDeD. FAILURe TO DO SO
mAY cAUSe DAmAGe AND/OR peRSONAL INJURY AND WILL INvALIDATe THe WARRANTY.
1. SAFeTY INSTRUcTIONS
1.1
eLecTRIcAL SAFeTY
WARNING!
It is the responsibility of the owner and the operator to read, understand and comply with the following:
You must check all electrical products, before use, to ensure that they are safe. You must inspect power cables, plugs, sockets
and any other connectors for wear or damage. You must ensure that the risk of electric shock is minimised by the installation of
appropriate safety devices. A residual Current Circuit Breaker (rCCB) should be incorporated in the main distribution board.
We also recommend that a residual Current Device (rCD) is used. It is particularly important to use an rCD with portable
products that are plugged into a supply which is not protected by an rCCB. If in any doubt consult a qualified electrician. You
may obtain a residual Current Device by contacting your Sealey dealer.
You must
also read and understand the following instructions concerning electrical safety.
1.1.1 the
electricity at Work Act 1989
requires that all portable electrical appliances, if used on business premises, are
tested by a qualified electrician, using a Portable Appliance tester (PAt), at least once a year.
1.1.2 the
Health & Safety at Work Act 1974
makes owners of electrical appliances responsible for the safe condition of
those appliances and the safety of the appliance operators.
If in any doubt about electrical safety, contact a
qualified electrician.
1.1.3 ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply. See
1.1.1. and 1.1.2. and use a Portable Appliance tester.
1.1.4 ensure that cables are always protected against short circuit and overload.
1.1.5 regularly inspect power supply cables and plugs for wear or damage and check all
connections to ensure that none are loose.
1.1.6
Important:
ensure that the voltage marked on the appliance matches the power supply
to be used and that the plug is fitted with the correct fuse.
1.1.7 ensure the 110 volt transformer or generator is of an adequate rating for the cleaner.
1.1.8
DO NOT
pull or carry the appliance by its power supply lead.
1.1.9
DO NOT
pull the plug from the socket by the power cable.
1.1.10
DO NOT
use worn or damaged cables, plugs or connectors. Immediately have any
faulty item repaired or replaced by a qualified electrician.
Ensure the unit is correctly earthed via a three-pin 110V plug.
a) Connect the gREEN/yEllOw earth wire to the earth terminal ‘PE’.
b) Connect the bROwN live wire to the live terminal ‘l/+’.
c) Connect the bluE neutral wire to the neutral terminal.
d) After wiring, check that there are no bare wires, that all wires have been
correctly connected, that the cable outer insulation extends past the cable
restraint and that the restraint is tight.
1.1.11 If an extension reel is used it should be fully unwound before connection. A reel with an rCD fitted is recommended
since any appliance plugged into it will be protected. the cable core section is important and should be at least
1.5mm², but to be absolutely sure that the capacity of the reel is suitable for this product and for others which may be
used in the other output sockets, we recommend the use of 2.5mm² section cable.
1.2
GeNeRAL SAFeTY
Disconnect the cleaner from the power supply before servicing, changing accessories, or performing any maintenance.
use only genuine parts and accessories. unauthorised parts and accessories may be dangerous and will invalidate
your warranty.
maintain the cleaner in good condition. use an authorised agent for servicing. Keep machine clean, but
DO NOT
use solvents.
for dry vacuuming ensure the locking cartridge filter is firmly in place before operating the cleaner.
DO NOT
operate the unit without the locking cartridge filter in place (except when wet vacuuming).
using the cleaner without a locking cartridge filter will cause machine faults and will invalidate your warranty.
Wear protective clothing and gloves.
DO NOT
allow children or untrained persons to operate the cleaner.
DO NOT
place attachments close to your face (especially eyes, ears, etc). Do not point the hose end at other persons
or animals.
DANGeR! DO NOT
vacuum hot or glowing ash, cigarette ends, inflammable, explosive, corrosive or other dangerous
substances.
DO NOT
operate the unit without the locking cartridge filter or optional dust bag (except when wet vacuuming).
DO NOT
leave machine running unattended. turn power supply
OFF
, and
DO NOT
leave the vicinity until motor has
come to a complete stop.
DO NOT
operate the cleaner while under the influence of drugs, alcohol or impairing medication, or if you are tired.
DO NOT
use the cleaner in the rain or in very damp conditions.
DO NOT
use the cleaner for a task it is not designed to perform.
When not in use, store the cleaner in a safe, dry, childproof location.
Fuse rating: 16 Amp
