4. RATINGS PLATE
Detailed technical data relative to the performance of the welding set is located on the back panel.
NOTE:
The rating plate detailed in fig 1 is an example only intended to assist with the explanations of the symbols. To determine the
correct technical values of the welding set refer to the data plate on your machine and the specification table above.
1:
The relevant standard.
2:
Inverter-transformer-rectifier symbols.
3:
Symbol indicates welding with a continuous flow of welding wire.
Manual arc welding with covered electrode.
4:
Symbol for Single-phase AC supply.
5:
Rating of internal protection provided by casing.
6:
Output:
U
0
: Maximum open-circuit voltage.
I
2
, U
2
: Current and corresponding voltage.
X: Welding ratio based on a 10 minute cycle.
20% indicates 2 minutes welding and 8 minutes rest,
100% would indicates continuous welding.
7:
Mains Supply:
U
1
: Rated supply voltage and frequency.
I
1
max: Maximum current.
I
1
eff: Maximum effective current.
8:
A/V - A/V: Welding current adjustment range and corresponding voltages.
9:
Serial Number.
5. ASSEMBLY
WARNING!
Disconnect from mains power supply before any assembly.
5.1.
FITTING A REEL OF WIRE
5.1.1.
Release the catch (fig 2) and lift up the feed compartment cover (fig 3).
5.1.2.
Unscrew and remove the star knob, spring and retaining disc (fig 3) and place to one side.
5.1.3.
Slide the wire reel onto the reel holder (fig 4).
5.1.4.
Reattach the star knob, spring and retaining disc and fully tighten (fig 4).
8
DO NOT
over tighten.
5.1.5.
Ensure that the wire is spooling off from the bottom of the wire reel in the direction of the wire drive unit (fig 4).
5.2.
FEEDING THE WIRE THROUGH THE TORCH
WARNING!
Ensure that the wire feed roller, the wire guide hose and the contact tip of the torch correspond to the diameter of the
wire used and are fitted correctly.
5.2.1.
To access the drive mechanism pull the pressure adjustment knob (fig 4) towards you and allow to it to rotate downwards.
5.2.2.
Rotate the pressure roller housing up towards the right (fig 5).
5.2.3.
Ensure that the required feed groove (Ø0.6mm and Ø0.8mm wire) is in line with the wire path. See section 5.4 on how to reverse or
change the roller.
5.2.4.
Release the wire from the reel and trim off any bent portion and remove any burrs
WARNING!
Prevent the wire from uncoiling by keeping the wire under tension at all times.
5.2.5.
Straighten the end of wire and gently push it through the flexible sheath (fig 5), over the feed roller groove and then into the torch
cable liner.
Original Language Version
© Jack Sealey Limited
fig.1
fig.2
fig.3
fig.4
fig.4
fig.5
fig.6
Minimig100 Issue 1 23/05/22
Retaining
disc
spring
star
knob
Wire
feed
assembly
