4. OPERATION
4.1.
Remove USB cover on the rear of the lamp unit to reveal the USB charging point and insert the power cable.
4.2.
Plug the cable into an appropriate power source. Charging will take approximately 2.5 hr.
4.3.
When fully charged the Power LED will change from red to green.
4.4.
When charged, remove USB cable and replace the USB cover.
4.5.
Adjust the head band size for a comfortable and secure fit using the adjusters
4.6.
The unit has five operating modes. These are On/Off, Strip Light 100%, Strip Light 30%, Torch 100%, Torch 30%.
4.7.
To switch the unit on, press On/Off Mode Selector and the Strip Light will illuminate at 100%. Press the Selector again, and the
Strip Light will reduce to 30%. Press the Selector again and the Torch will illuminate at 100%. Press the Selector again and
the Torch will reduce to 30%. A further press on the Selector will turn the unit off.
4.8.
To turn the Motion Sensor on, press the Motion Sensor Selector. The Power LED will illuminate to half red and half green.
4.9.
The Sensor is activated by covering the Motion Sensors on the side of the lamp unit. Press the Motion Sensor Selector to
turn the function off.
5. MAINTENANCE
5.1.
Keep the torch clean by wiping with a damp cloth.
5.2.
Store torch in a dry childproof area.
Original Language Version
© Jack Sealey Limited
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
01284 703534
www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
BATTERY REMOVAL
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products
containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack
Sealey Ltd’s Batteries Producer Registration Number (BPRN) is BPRN00705.
BATTERY REMOVAL
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products
containing batteries (as defined within these regulations), that they are registered with Valpak’s registered compliance scheme. Jack
Sealey Ltd Batteries Producer Registration Number (BPRN) is BPRN00705.
Note
: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important
: No Liability is accepted for incorrect use of this product.
Warranty
: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Strip light
Torch
O
n/Off
Mode
Selector
Motion
Sensor Selector
Power LED
Sensor
Detectors
Head Band
Adjustment
Head Band
Adjustment
HT104R Issue 1 04/10/21
