6. CLEANING
FOR OPTIMUM PERFORMANCE IT IS VERY IMPORTANT TO ENSURE THE GUN IS CORRECTLY CLEANED AFTER EACH
USE.
Disconnect from the air supply before attempting any cleaning or maintenance.
6.1.
Cleaning the gun
6.1.1.
Immerse the front end of the gun only in solvent. The solvent should just cover the fluid connection. (fig.5).
6.1.2.
Use a bristle brush and solvent to wash off accumulated paint.
6.1.3.
Do not immerse the entire gun in solvent as this will cause lubricants on the rubber seals to dissolve. Dirty solvent may also clog
narrow passages in the gun.
6.1.4.
Flush the gun through with clean solvent.
6.1.5.
Wipe the outside of the gun with a dampened solvent rag.
6.2.
Air nozzle, fluid nozzle and needle assembly
6.2.1.
To clean the nozzles, soak them in solvent to dissolve any dried material then blow them clean with air. Handle all nozzles carefully
and do not make any alterations in the gun.
6.2.2.
If you need to probe the holes in the nozzles, be sure to use a tool that is softer than brass; do not use metal instruments.
6.2.3.
Adjust the fluid needle valve so that when the gun is triggered, air flow occurs before fluid flow.
6.3.
Maintenance
6.3.1.
Disassemble using the supplied spanner, socket and hex key.
6.3.2.
Take care when re-assembling. Firstly screw parts hand tight to avoid cross-threading then tighten with spanner. If a part cannot easily
be turned by hand, check that you have the correct part, or unscrew, realign and try again. DO NOT use excessive force when
re-assembling.
6.3.3.
Lubricate the gun daily with a light machine oil.
6.3.4.
If you change the nozzle size, ensure the complete nozzle set is exchanged. Insert paint nozzle before putting the paint needle in.
HP01 Issue No:1 04/11/15
Original Language Version
© Jack Sealey Limited
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
No liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
Sole UK Distributor, Sealey Group.
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk.
IP32 7AR
www.sealey.co.uk
01284 757500
01284 703534
Web
Environmental Protection
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment.
When the product becomes completely unserviceable and requires disposal, drain off any fluids (if applicable)
into approved containers and dispose of the product and the fluids according to local regulations.
fig.5
Parts support is available for this product. To obtain a parts listing and/or diagram,
please log on to www.sealey.co.uk, email [email protected] or telephone 01284 757500.
