The H-3000 is a portable spot welder with an electronic timer which enables precision spot welding on low carbon sheet steel ( using the standard
arms supplied ) up to a thickness of 1+1mm. The unit also features welding pressure adjustment. The H-3000 is similar to the H-3000
2 but has additional
features and capabilities enabling welding on low carbon sheet steel ( using the standard arms supplied ) up to a thickness of 2+2mm. The H-3000 is
microprocessor controlled enabling the following functions to be selected from the control panel. A) Welding time. B) Welding thickness. C) Selection
of normal or pulse welding modes. Both units are supplied with standard 120mm arms and electrodes.
MAIN FEATURES
1. Electrode pressure adjustment screw
2. Right / left handgrip.
3. Position for eyebolt. ( Eyebolt not supplied.)
4. Moving welding arm.
5. Fixed welding arm.
6. Power supply cable.
7. Rating plate.
8. Microswitch.
9. Welding time adjustment. (H-3000)
10. Control panel. (H-3000S)
11. Welding lever
2. INTRODUCTION
MODEL NO.
H-3000
H-3000S
Voltage...........................................230v 1ph ......................230v 1ph
Power at 50% ....................................1.3kVA ..........................2.5kVA
Max. welding power...........................6.6kVA ...........................14kVA
No Load Voltage ...................................... 2V ..............................2.5V
Max. short circuit current .....................3.8kA ............................6.3kA
Weight ...............................................10.5kg .......................... 10.5kg
Airborne noise level ...................... <70dB(A) ......................<70dB(A)
MODEL NO.
Dimensions .........................440 x 100 x 185 ...........440 x 100 x 185
Plug and Socket .................................... 16A ..........................16/32A
Delayed Mains Fuses ............................ 16A ...............................25A
Max spot weld thickness ..................1+1mm .........................2+2mm
Min.rest period between welds ... 20seconds ....................20seconds
Maximum clamping force ...................120kg ........................... 120kg
Projection of arms ............................120mm .........................120mm
3. TECHNICAL SPECIFICATION
4. ELECTRICAL CONNECTIONS
WARNING!
Ensure that you read and understand the safety instructions in Section 1.
4.1.
Connection to mains power supply.
Before making any electrical connections check that the voltage of the available power supply is suitable for the spot
welder model that you have purchased. ( See specification above.)
4.2
The H-3000&S
require a 30amp. supply and are suitable for either single phase or three phase connection.
4.3
The H-3000 requires a 16amp plug and the SR123 requires a 32 amp plug. If connecting to a 30amp supply wire the plug as shown on
page 1. If the unit is to be connected to a 3 phase supply this must be done by a
qualified electrician
.
4.4
The mains power supply should be equiped with appropriate fuses or an automatic cut-out switch arrangement.
4.5
If more than one welding machine is to be installed consult a
qualified electrician
regarding a suitable 3 phase supply.
4.6
Before proceeding to set up and use the welder, ensure that the electrical connections have been made correctly.
fig. 1
A FULL RANGE OF ARMS AND ELECTRODES IS AVAILABLE FOR THE H-3000. REFER TO LAST PAGE OF
INSTRUCTION OR CONTACT YOUR LOCAL SEALEY DEALER FOR FURTHER INFORMATION.
Original Language Version
