3.4
Remove the locking pin from the base unit and insert the base unit itself into the
open end of the adaptor as shown in fig.C and slide it in until the holes in the sides of
the base unit are aligned with the holes in the sides of the adaptor.
3.5
Insert the locking pin through both the adaptor and the base unit and secure it with
the ‘R’ clip provided on the chain, fig.D.
3.6
Rotate the ‘T’ handle clockwise until the lifting pad is in contact with the engine sump
as shown in fig.E. Guide the pad onto the sump to ensure that its full surface area is
in contact with the engine.
3.7
If the unit is being used to support the engine only, do not over tighten the ‘T’ handle
as this will put a strain on the engine mountings.
3.8
If the unit is being used to raise the engine then the engine mountings must be
released before turning the ‘T’ handle further.
4.1
Keep the engine support clean and wipe off any oil or grease.
4.2
Lubricate the ‘T’ handle thread occasionally with a copper based grease.
4.3
Before each use check condition of main unit and adaptors. If any parts are damaged
in any way they should not be used.
4. MAINTENANCE
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT:
No liability is accepted for incorrect use of this product.
WARRANTY:
Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION:
For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
www.sealey.co.uk
Web
C
D
E
3. OPERATING INSTRUCTIONS
!
WARNING! Before use, ensure that the vehicle handbrake is on and that you have safe access to the underside of the vehicle.
!
WARNING! Before use, ensure that the cross member on the underside of the vehicle is structurally sound and undamaged. Do
not proceed if you are doubtful about the condition of the mounting area.
3.1.
Obtain the correct adaptor for the vehicle you are working on. Do not attempt to use an adaptor that does not fit properly and do not
attempt to modify another adaptor to fit.
3.2.
Looking form the front of the vehicle place the hook portion of the adaptor over the cross member near to the engine. The adaptor
should be positioned facing front to back along the length of the vehicle as shown in fig.A.
3.3
Lock the adaptor onto the vehicle cross member using the clamp and screw knob as shown in fig.B. If necessary move the adaptor
sideways slightly on the cross member in order to get a good fit. Tighten the clamp ensuring that it is in contact with the cross member
and the adaptor cannot move.
A
B
ES200, ES200-01 to 29 - 3 - 220207
